Note: Ingredients listed on restricted chemical lists
EC/CAS
72623-86-0
Name of the chemical
Lubricating oils (petroleum), C15-30, hydrotreated neutral oil-based; Base oil — unspecified (A complex combination of hydrocarbons obtained by treating light vacuum gas oil and heavy vacuum gas oil with hydrogen in the presence of a catalyst in a two stage process with dewaxing being carried out between the two stages. It consists predominantly of hydrocarbons having carbon numbers predominantly in the range of C15 through C30 and produces a finished oil having a viscosity of approximately 15 10-6 m2.s-1 at 40 °C. It contains a relatively large proportion of saturated hydrocarbons.)
Concentration
N/A
EC/CAS
64742-65-0
Name of the chemical
Distillates (petroleum), solvent-dewaxed heavy paraffinic; Base oil — unspecified (A complex combination of hydrocarbons obtained by removal of normal paraffins from a petroleum fraction by solvent crystallisation. It consists predominantly of hydrocarbons having carbon numbers predominantly in the range of C20 through C50 and produces a finished oil with a viscosity of not less than 19 10-6 m2.s-1 at 40 °C.)
Concentration
N/A
EC/CAS
64742-54-7
Name of the chemical
Distillates (petroleum), hydrotreated heavy paraffinic; Base oil — unspecified (A complex combination of hydrocarbons obtained by treating a petroleum fraction with hydrogen in the presence of a catalyst. It consists of hydrocarbons having carbon numbers predominantly in the range of C20 through C50 and produces a finished oil of at least 19 10-6 m2.s-1 at 40 °C. It contains a relatively large proportion of saturated hydrocarbons.)
Concentration
N/A
EC/CAS
72623-87-1
Name of the chemical
Lubricating oils (petroleum), C20-50, hydrotreated neutral oil-based; Base oil — unspecified (A complex combination of hydrocarbons obtained by treating light vacuum gas oil, heavy vacuum gas oil and solvent deasphalted residual oil with hydrogen in the presence of a catalyst in a two stage process with dewaxing being carried out between the two stages. It consists predominantly of hydrocarbons having carbon numbers predominantly in the range of C20 through C50 and produces a finished oil with a viscosity of approximately 32 10-6 m2.s-1 at 40 °C. It contains a relatively large proportion of saturated hydrocarbons.)
Concentration
N/A
General Information
Revision date
2019-11-10
Product name
KLONDIKE Wet Brake Lubricant Full Synthetic
1.2.1 Relevant identified uses
Universal Tractor Fluid
1.2.2. Uses advised against
Uses other than those described above
supplier name
KLONDIKE Lubricants Corporation
Icons in SDS
Company Information
company name
KLONDIKE Lubricants Corporation
e-mail address of the competent person responsible for the Safety Data Sheet
info@klondikelubricants.com
GHS Information
Signal word
Danger
Section 2
SECTION 2: Hazards identification
Classification of the hazardous product: Carcinogenicity Category 1B
Hazard statements
class symbols: May cause cancer.
Signal word
Danger
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Wear protective gloves/protective clothing/eye protection/face protection.
Response
IF exposed or concerned: Get medical advice/attention.
Storage
Store locked up.
Disposal
Dispose of contents/container to a suitable disposal site in accordance with local/national/international regulations. Other hazards known to the supplier with respect to the hazardous product: Physical hazards not otherwise None known. classified Health hazards not otherwise classified None known.