Note: Ingredients listed on restricted chemical lists
EC/CAS
68476-86-8
Name of the chemical
Petroleum gases, liquefied, sweetened
Concentration
40-50
EC/CAS
108-88-3
Name of the chemical
Toluene
Concentration
20-30
EC/CAS
1317-33-5
Name of the chemical
molybdenum disulphide
Concentration
0.1-1.0
EC/CAS
71-43-2
Name of the chemical
Benzol
Concentration
<0.1
General Information
Version
1.03
Revision date
2018-06-26
Product name
80-722 MOLY-GUARD DRY MOLY LUBE
1.2.1 Relevant identified uses
and restrictions on use
1.2.2. Uses advised against
None
supplier name
Dry Moly Lubricant
Emergency telephone
1-800-424-9300
Icons in SDS
Company Information
company name
Kimball Midwest
GHS Information
Signal word
DANGER
Hazard Codes
Hazard statements (CLP)
H222, H223, H229, H280, H304, H315, H319, H336, H361
Hazard statements
Code
Statements
H222
Extremely flammable aerosol
Section 2
SECTION 2: Hazards identification
Classification Skin corrosion/irritation Category 2 Serious eye damage/eye irritation Category 2A Reproductive Toxicity Category 2 Specific target organ toxicity (single exposure) Category 3 Specific target organ toxicity (repeated exposure) Category 2 Aspiration toxicity Category 1 Flammable aerosols Category 1 Gases under pressure Compressed Gas
2.2 Label elements
Emergency Overview DANGER
Hazard statements
Causes skin irritation Causes serious eye irritation. Suspected of damaging fertility or the unborn child May cause drowsiness or dizziness. May cause damage to organs (central nervous system, lungs, and respiratory system) through prolonged or repeated exposure. May be fatal if swallowed and enters airways. Extremely Flammable Aerosol Contains gas under pressure; may explode if heated Appearance Opaque Physical state Aerosol Odor Solvent
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Wash hands and face thoroughly after handling Wear protective gloves/protective clothing/eye protection/face protection. Do not breathe dust/fume/gas/mist/vapors/spray. Use only outdoors or in a well-ventilated area Keep away from heat, sparks, open flames, hot surfaces - No smoking. Do not spray on an open flame or other ignition source. Pressurized container: Do not pierce or burn, even after use
Response
If exposed or concerned: Get medical advice/attention. IF IN EYES:Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention. IF ON SKIN: Wash with plenty of soap and water. If skin irritation occurs: Get medical advice/attention. Take off contaminated clothing and wash it before reuse IF INHALED: Remove person to fresh air and keep comfortable for breathing. Call a POISON CENTER or doctor/physician if you feel unwell. IF SWALLOWED: Immediately call a POISON CENTER/doctor/physician. Do NOT induce vomiting.
Storage
Store locked up Protect from sunlight. Store in a well-ventilated place Keep container tightly closed. Do not expose to temperatures exceeding 122°F (50°C)
Precautionary statements
Disposal Dispose of contents/container to an approved waste disposal plant.
2.3 Other hazards
None
Further information
0.59596% of the mixture consists of ingredient(s) of unknown toxicity.
2.1 Classification of the substance or mixture
Skin corrosion/irritation Category 2 Serious eye damage/eye irritation Category 2A Reproductive Toxicity Category 2 Specific target organ toxicity (single exposure) Category 3 Specific target organ toxicity (repeated exposure) Category 2 Aspiration toxicity Category 1 Flammable aerosols Category 1 Gases under pressure Compressed Gas