Note: Ingredients listed on restricted chemical lists
EC/CAS
200-578-6/64-17-5
Name of the chemical
Ethanol
Concentration
60-70%
EC/CAS
200-661-7/67-63-0
Name of the chemical
Propan-2-ol
Concentration
5-10%
General Information
Version
1.0.0
Revision date
2024-05-02
Product name
Kiilto Pro Overfladedesinfektion 75% - Wipes
1.2.1 Relevant identified uses
Disinfection of smooth surfaces PT 2 Disinfectants and algaecides not intended for direct application to humans or animals PT 4 Food and feed area Biocide. Use biocides safely. Always read the label and product information before use
1.2.2. Uses advised against
For professional users only Inadvisable uses Hand disinfection. By prolonged contact, the product may dry the skin
supplier name
KiiltoClean A/S
Emergency telephone
+45 64 71 21 12
Icons in SDS
Company Information
company name
KiiltoClean A/S
e-mail address of the competent person responsible for the Safety Data Sheet
info.dk@kiilto.com
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H225, H319
Hazard statements
Code
Statements
H225
Highly Flammable liquid and vapour
Section 2
SECTION 2: Hazards identification
Signal word
Danger
Hazard statements
H225 Highly flammable liquid and vapour. H319 Causes serious eye irritation.
Precautionary statements
P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. P233 Keep container tightly closed. P280 Wear protective gloves. P305+351+338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. P501 Dispose of contents/container as hazardous waste. Rinsed container can be sorted as plastic. Used wipes can be disposed of as household waste..
Additional information
Use Surface disinfection Type of formulation: Ready to use wipe. Active substances: 623 g/kg Ethanol. Dosage: Ready to use. Use on visibly clean surfaces. Visibly dirty surfaces should be cleaned before disinfection. Before use Twist off the lid and make a hole in the center of the foil. Pull a wipe from the center of the roll and pass it through the lid. Put the lid on and pull the wipe all the way up. Be sure to close the lid completely after use to avoid drying out. Work the area to be disinfected thoroughly with a wipe. Hold the wipe flat and wipe the surface in an S shape so that the liquid is distributed evenly over the entire surface. The surface must be wet during the entire contact time. If evaporation occurs faster, the procedure is repeated. Allow the surface to air dry.
2.3 Other hazards
The product does not contain any PBT or vPvB substances. Endocrine disrupting properties: None known.
