Note: Ingredients listed on restricted chemical lists
EC/CAS
9016-87-9
Name of the chemical
4,4'-Methylendiphenyldiisocyanat tech. (Polymeres) MDI, pMDI (in Form atembarer Aerosole, A-Fraktion)
Concentration
≥20-<50
EC/CAS
201-114-5/78-40-0
Name of the chemical
Phosphoric acid, triethyl ester, TEP
Concentration
≥1-<3
General Information
Revision date
2024-05-16
Product name
HYPER FOAM FIRE G
1.2.1 Relevant identified uses
Polyurethane-sealant
1.2.2. Uses advised against
All uses other than recommended ones
Emergency telephone
+39-0536-816511, 01 809 2166, +356 2395 2000
Icons in SDS
Company Information
company name
KERAKOLL France
e-mail address of the competent person responsible for the Safety Data Sheet
safety@kerakoll.com
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H222, H229, H315, H317, H319, H334, H335, H351, H373
Hazard statements
Code
Statements
H222
Extremely flammable aerosol
Section 2
SECTION 2: Hazards identification
Regulation (EC) No. 1272/2008 [CLP] Classification of the substance or mixture
Adverse physicochemical, human health and environmental effects
No other hazards
Hazard statements
H222, H229 Extremely flammable aerosol. Pressurized container: may burst if heated. H315 Causes skin irritation. H317 May cause an allergic skin reaction. H319 Causes serious eye irritation. H334 May cause allergy or asthma symptoms or breathing difficulties if inhaled. H335 May cause respiratory irritation. H351 Suspected of causing cancer. H373 May cause damage to organs through prolonged or repeated exposure.
Precautionary statements
P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. P211 Do not spray on an open flame or other ignition source. P251 Do not pierce or burn, even after use. P271 Use only outdoors or in a well-ventilated area. P280 Wear protective gloves and eye protection. P304+P340 IF INHALED: Remove person to fresh air and keep comfortable for breathing. P305+P351+P33 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy 8 to do. Continue rinsing. P410+P412 Protect from sunlight. Do not expose to temperatures exceeding 50 °C/122°F.
Contains
4,4’ diphenylmethanediisocyanate, isomere, homologe and mixtures
Annex XVII - Restrictions on the manufacture, placing on the market and use of certain dangerous substances, mixtures and articles
Persons already sensitised to diisocyanates may develop allergic reactions when using this product. Persons suffering from asthma, eczema or skin problems should avoid contact, including dermal contact, with this product. This product should not be used under conditions of poor ventilation unless a protective mask with an appropriate gas filter (i.e. type A1 according to standard EN 14387) is used As from 24 August 2023 adequate training is required before industrial or professional use.
2.3 Other hazards
No PBT, vPvB or endocrine disruptor substances present in concentration >= 0.1% No other hazards
2.1 Classification of the substance or mixture
Regulation (EC) n. 1272/2008 (CLP) Aerosols 1 Extremely flammable aerosol. Pressurized container: may burst if heated. Skin Irrit. 2 Causes skin irritation. Eye Irrit. 2 Causes serious eye irritation. Resp. Sens. 1B May cause allergy or asthma symptoms or breathing difficulties if inhaled. Skin Sens. 1 May cause an allergic skin reaction. Carc. 2 Suspected of causing cancer. STOT SE 3 May cause respiratory irritation. STOT RE 2 May cause damage to organs through prolonged or repeated exposure. Adverse physicochemical, human health and environmental effects: No other hazards