PARTEZE MOLD RELEASE

Kano Laboratories

Revision date : 2017-10-10

SDS Library

Move your SDS library online today

Check Icon
Setup – Easy setup with our database of 16 million+ SDSs
Check Icon
Up-to-date – Your SDS get updated to latest versions.
Check Icon
Employee access – Tablets, Smartphones, or link from Corporate Intranet
Check Icon
Safety – One-click access to first aid information.
Check Icon
Labels – Generate Secondary Container Labels with just one click.
GHS02 GHS04 GHS07 GHS08
Health risk rating 5
Safety risk rating 4
Environmental risk rating 5

Note: Ingredients listed on restricted chemical lists

EC/CAS

64742-49-0

Name of the chemical

Naphtha (petroleum), hydrotreated light

Concentration

N/A

EC/CAS

68476-86-8

Name of the chemical

Petroleum gases, liquefied, sweetened

Concentration

N/A

EC/CAS

63148-62-9

Name of the chemical

polydimethylsiloxane (Mw > 6 800 Da)

Concentration

N/A

General Information

Revision date

2017-10-10

Product name

PARTEZE MOLD RELEASE

1.2.2. Uses advised against

None

Emergency telephone

615-833-4101

Icons in SDS

GHS02 GHS04 GHS07 GHS08

Company Information

company name

Kano Laboratories

GHS Information

Signal word

DANGER

Section 2

2.1 Classification of the substance or mixture

Note: This product is a consumer product and is labeled in accordance with the US Consumer Product Safety Commission regulations which take precedence over OSHA Hazard Communication labeling. The actual container label will not include the

2.2 Label elements

below.The labeling below applies to industrial/professional products Skin corrosion/irritation Category 2 Specific target organ toxicity (single exposure) Category 3 Aspiration toxicity Category 1 Flammable aerosols Category 1 Gases under pressure Compressed Gas Emergency Overview DANGER

Hazard statements

Causes skin irritation May cause respiratory irritation. May cause drowsiness or dizziness. May be fatal if swallowed and enters airways Extremely Flammable Aerosol Contains gas under pressure; may explode if heated Appearance Clear Physical state Aerosol Odor Solvent

Prevention

Wash face, hands and any exposed skin thoroughly after handling. Wear protective gloves Avoid breathing mist/vapors/spray. Use only outdoors or in a well-ventilated area Keep away from heat/sparks/open flames/hot surfaces.-No smoking. Do not spray on an open flame or other ignition source. Pressurized container: Do not pierce or burn, even after use

Response

Specific treatment (see first aid on this label) IF ON SKIN: Wash with plenty of soap and water. If skin irritation occurs: Get medical advice/attention Take off contaminated clothing and wash before reuse IF INHALED : Remove person to fresh air and keep comfortable for breathing. Call a POISON CENTER or doctor/physician if you feel unwell IF SWALLOWED: Immediately call a poison center/doctor Do NOT induce vomiting.

Storage

Store locked up Store in a well-ventilated place. Keep container tightly closed. Protect from sunlight. Do not expose to temperatures exceeding 50 °C/122 °F

Precautionary statements

Disposal Dispose of contents/container to an approved waste disposal plant

2.3 Other hazards

None

Further information

0% of the mixture consists of ingredient(s) of unknown toxicity.

SDS Library

Move your SDS library online today

Check Icon
Setup – Easy setup with our database of 16 million+ SDSs
Check Icon
Up-to-date – Your SDS get updated to latest versions.
Check Icon
Employee access – Tablets, Smartphones, or link from Corporate Intranet
Check Icon
Safety – One-click access to first aid information.
Check Icon
Labels – Generate Secondary Container Labels with just one click.