Racing

Hazard statements (CLP)

H226, H302, H317, H318, H335, H336, H400, H410

Code

Statements

H226

Flammable liquid and vapour

SECTION 2: Hazards identification

1272/2008] Classification of the substance or mixture

Product definition

Mixture

Signal word

Danger.

Hazard statements

H226 - Flammable liquid and vapour. H302 - Harmful if swallowed. H317 - May cause an allergic skin reaction. H318 - Causes serious eye damage. H335 - May cause respiratory irritation. H336 - May cause drowsiness or dizziness. H410 - Very toxic to aquatic life with long lasting effects.

Precautionary statements

General : P101 - If medical advice is needed, have product container or label at hand. P102 - Keep out of reach of children. P103 - Read carefully and follow all instructions.

Prevention

P280 - Wear protective gloves. P280 - Wear eye or face protection. P210 - Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. P271 - Use only outdoors or in a well-ventilated area. P273 - Avoid release to the environment. P261 - Avoid breathing vapour. P270 - Do not eat, drink or smoke when using this product. P264 - Wash hands thoroughly after handling.

Response

P391 - Collect spillage. P301 + P312 - IF SWALLOWED: Call a POISON CENTER or doctor if you feel unwell. P330 - Rinse mouth. P304 + P340 + P312 - IF INHALED: Remove person to fresh air and keep comfortable for breathing. Call a POISON CENTER or doctor if you feel unwell. P362 + P364 - Take off contaminated clothing and wash it before reuse. P302 + P352 - IF ON SKIN: Wash with plenty of water. P333 + P313 - If skin irritation or rash occurs: Get medical advice or attention. P305 + P351 + P338, P310 - IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a POISON CENTER or doctor.

Storage

P405 - Store locked up. P403 + P233 - Store in a well-ventilated place. Keep container tightly closed.

Disposal

P501 - Dispose of contents and container in accordance with all local, regional, national and international regulations.

Hazardous Ingredients

dicopper oxide hydrocarbons, C9, aromatics colophony

Supplemental label elements

Not applicable.

Additional information

Antifouling products. Active substances: dicopper oxide (CAS 1317-39-1) 35.59 % w/ w. : NO-2023-0253 Consumer Field(s) of use Outdoor. Vessel category 1. Paint for leisure crafts with a hull length of maximum 24 meter and a berth in marine environment. Application method(s) Brush, roller. Vessel Cat. 1 Annual application maintenance) 1 coat (DFT 40 µm) per year. Application rate 0.08 L/m2. In case of a first launching of a brand new boat, ensure that there are no unpainted areas. Comply with the instructions for use. The surface must be clean and dry. Products must be stirred well to a homogenous solution prior to use. Frequently stirring during use is recommended. Apply the product uniformly on the surfaces to be treated at the application rate so that efficacy is ensured during at least single fouling season. The coating must be dry before immersion. The users should report straightforward to the registration holder in case of inefficacy. Risk mitigation measures: Brush and roller application including washing out of brush: Chemical goggles. Chemical resistant gloves (EN 374). Long sleeved shirt and trousers/ Protective coated coverall (e.g., type 6, EN 13034). Removing paint by dry sanding: Chemical goggles. Dust mask (respiratory mask with an assigned protection factor of 4) should be worn by non-professionals when removing antifouling paint by dry grinding. Chemical resistant gloves (EN 374). Coverall or long sleeved shirt and trousers. Use only outdoors or in a well-ventilated area. Avoid breathing vapor/mist/dust. Avoid contact with skin and eyes. Wash hands after handling/use. Wash contaminated clothing before reuse. Appropriate gloves should be supplied with products for nonprofessional users to ensure use of gloves when applying the product. Children should be kept away from the painted boat until the paint is dry. Unprotected persons should be kept out of treatment areas. Avoid release to the environment. Application, maintenance and repair activities shall (1) be conducted within a contained area to prevent losses and minimize emissions to the environment, meaning (2) on an impermeable hard standing with bunding or (3) on soil covered with an impermeable material. Any losses or waste containing dicopper oxide shall be collected for reuse or disposal. If medical advice is needed, have product container or label at hand. IF INHALED: Move to fresh air and keep at rest in a position comfortable for breathing. If symptoms Call 112/ambulance for medical assistance. If no symptoms Call a POISON CENTRE or a doctor. IF SWALLOWED: Immediately rinse mouth. Give something to drink, if exposed person is able to swallow. Do NOT induce vomiting. Call 112/ambulance for medical assistance. IF ON SKIN: Immediately wash skin with plenty of water. Thereafter take off all contaminated clothing and wash it before reuse. Continue to wash the skin with water for 15 minutes. Call a POISON CENTRE or a doctor. IF IN EYES: Immediately rinse with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing for at least 15 minutes. Call 112/ambulance for medical assistance. Application solutions must be collected and disposed of as hazardous waste. They must not be released to soil, ground- and surface water or any kind of sewer. Keep out of reach of children and non-target animals/pets. Keep the containers in a dry, cool, well-ventilated place and away from sources of heat and ignition. Do not store at temperatures above 30˚C. Containers must be kept tightly closed. Hazardous waste due to toxicity. EUH208 - Contains methyl methacrylate and n-butyl methacrylate. May produce an allergic reaction. Total binder range (including solvents): 13.00-20.00 % (Red/Black), 12.00-20.00 % (Blue/Dark Blue) Professional : For professional use only. Field(s) of use: Indoor use. Outdoor use. Vessel categories: 1. Paint for leisure crafts with a hull length of maximum 24 meter and a berth in marine environment. 3. Paint for seagoing vessels for trade or business, naval and governmental vessels, and on super yachts (marine water). Other structures in marine water like: Mariculture equipment other than fish nets (such as lobster pots), buoys and other small objects, sluice doors, harbour constructions, inlet pipes of e.g. cooling systems, marine sensors, offshore constructions. The products are not intended for use in aquaculture. Application method(s): Brush, roller, airless spray. Vessel Cat. 1 Annual application (maintenance) 1 coat (DFT 40 µm) per year. Application rate 0.08 L/m2. In case of a first launching of a brand new boat, ensure that there are no unpainted areas. Vessel Cat. 3: Drydock interval: 12 months. Max total DFT of 100 µm (one coat of 100 µm or two coats of 50 µm). Application rate 0.2 L/m2. Other structures Application rate may vary (0.08-0.2 L/ m2). Please consult with the authorisation holder. The surface must be clean and dry. Products must be stirred well to a homogenous solution prior to use. Frequently stirring during use is recommended. Apply the product uniformly on the surfaces to be treated at the application rate so that efficacy is ensured during at least single fouling season. The coating must be dry before immersion. The users should report straightforward to the registration holder in case of inefficacy. Risk mitigation measures Spraying and cleaning of spray equipment Chemical resistant gloves (4H, teflon, nitrile rubber or polyvinyl alcohol (PVA) gloves) (EN 374). Chemical goggles or face shield (EN 166). A protective coverall (at least type 6, EN-13034) (coverall material to be specified by the authorisation holder within the product information). Respiratory protection with an assigned protection factor (APF) of at least 10. Potman including cleaning spray equipment: Chemical resistant gloves (4H, teflon, nitrile rubber or polyvinyl alcohol (PVA) gloves) (EN 374). Chemical goggles or face shield (EN 166). A protective coverall (at least type 6, EN-13034) (coverall material to be specified by the authorisation holder within the product information). Respiratory protection with an assigned protection factor (APF) of at least 10. Brush and roller application: Chemical resistant gloves (4H, teflon, nitrile rubber or polyvinyl alcohol (PVA) gloves) (EN 374). Chemical goggles or face shield (EN 166). A protective coverall (at least type 6, EN-13034) (coverall material to be specified by the authorisation holder within the product information). Respiratory protection with an assigned protection factor (APF) 10. Sandblasting and gritfilling: Chemical resistant gloves (4H, teflon, nitrile rubber or polyvinyl alcohol (PVA) gloves) (EN 374). Chemical goggles or face shield (EN 166). A double coverall, a chemically resistant (at least type 3, EN-14605) coverall which is impermeable for the biocidal product information) with at least a long-sleeve, long-leg cotton coverall underneath. Respiratory protection with an assigned protection factor (APF) of at least 10. Use only outdoors or in a well-ventilated area. Avoid breathing vapor/mist/dust. Avoid contact with skin and eyes. Wash hands after handling/use. Wash contaminated clothing before reuse. Appropriate gloves should be supplied with products for nonprofessional users to ensure use of gloves when applying the product. Children should be kept away from the painted boat until the paint is dry. Unprotected persons should be kept out of treatment areas. Avoid release to the environment. Application, maintenance and repair activities shall (1) be conducted within a contained area to prevent losses and minimize emissions to the environment, meaning (2) on an impermeable hard standing with bunding or (3) on soil covered with an impermeable material. Any losses or waste containing dicopper oxide shall be collected for reuse or disposal. IF INHALED: Move to fresh air and keep at rest in a position comfortable for breathing. If symptoms: Call 112/ambulance for medical assistance. If no symptoms: Call a POISON CENTRE or a doctor. IF SWALLOWED: Immediately rinse mouth. Give something to drink, if exposed person is able to swallow. Do NOT induce vomiting. Call 112/ambulance for medical assistance. IF ON SKIN: Immediately wash skin with plenty of water. Thereafter take off all contaminated clothing and wash it before reuse. Continue to wash the skin with water for 15 minutes. Call a POISON CENTRE or a doctor. IF IN EYES: Immediately rinse with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing for at least 15 minutes. Call 112/ambulance for medical assistance. Application solutions must be collected and disposed of as hazardous waste. They must not be released to soil, ground- and surface water or any kind of sewer. Keep the containers in a dry, cool, well-ventilated place and away from sources of heat and ignition. Do not store at temperatures above 30˚C. Containers must be kept tightly closed. Hazardous waste due to toxicity. EUH208 - Contains methyl methacrylate and n-butyl methacrylate. May produce an allergic reaction. Total binder range (including solvents): 13.00-20.00 % (Red/Black), 12.00-20.00 % (Blue/Dark Blue). Type of formulation: AL – Any other liquid. Use Biocides Safely and Sustainably. It is illegal to use this product for uses or in a manner other than that prescribed on this label. Poison Information (Applicable for Ireland only): For information or to report a poisoning incident contact The National Poisons Information Centre, Beaumont Hospital, Dublin (01-809 2166), retain the label for reference. In compliance : IMO Antifouling System Convention compliant AFS/CONF/26 + IMO MEPC.331(76).

Annex XVII - Restrictions on the manufacture, placing on the market and use of certain dangerous substances, mixtures and articles

Not applicable.

Special packaging requirements

Containers to be fitted with child-resistant fastenings : Not applicable.

Tactile warning of danger

Yes, applicable.

2.3 Other hazards

Product meets the criteria for PBT or vPvB according : This mixture does not contain any substances that are assessed to be a PBT or a vPvB.

Other hazards which do not result in classification

None known.

2.1 Classification of the substance or mixture

Mixture Classification according to Regulation (EC) No. 1272/2008 [CLP/GHS] Flam. Liq. 3, H226 Acute Tox. 4, H302 Eye Dam. 1, H318 Skin Sens. 1, H317 STOT SE 3, H335 STOT SE 3, H336 Aquatic Acute 1, H400 Aquatic Chronic 1, H410 The product is classified as hazardous according to Regulation (EC) 1272/2008 as amended. See Section 16 for the full text of the H statements declared above. See Section 11 for more detailed information on health effects and symptoms. 2.2 Label elements