Polymaker N600 3D printing filament

Health hazards

Acute toxicity -Oral: Not classified Acute toxicity -Dermal: Not classified Acute toxicity -Inhalation: Category 5 Skin corrosion/irritation: Not classified Serious eye damage/eye irritation: Not classified Respiratory sensitization: Not classified Skin sensitization: Not classified Germ cell mutagenicity: Not classified Carcinogenicity: IARC 3 Reproductive toxicity: Not classified Specific Target Organ/Systemic Toxicity (Single Exposure): Not classified Specific Target Organ/Systemic Toxicity (Repeated Exposure): Not classified

Aspiration hazard

Not classified

Environmental hazards

Aquatic environmental hazards: Not classified Chronic environmental hazards: Not classified JF Polymers (Suzhou) Co. Ltd. All rights reserved. Page | 1 V 1.0

Prevention

Do not handle until all safety precautions have been read and understood. Keep away from ignition sources such as heat/ sparks/ open flame. -No smoking. Wear protective gloves and eye/face protection – as specified by the manufacturer / supplier or the competent authority. Volatile gases which may irritate eyes, nose and throat may be released. Use adequate local exhaust ventilation during and molding. Get medical advice/attention if you feel unwell. Sweep up and dispose of spilled resin to eliminate slipping hazard. Do not pile up bags too high in order to avoid injury caused by falling of the product.

Response

Wash thoroughly after handling. Get medical advice/attention if you feel unwell.

Storage

Store in a well ventilated place. Protect from sunlight. Do not pile up bags too high in order to avoid injury caused by falling of the product.

Disposal

Dispose of contents/container in accordance with regulation in a well-ventilated area.