Synthetic Cleaner Ink Remover

Hazard statements (CLP)

H226, H336, H360

Code

Statements

H226

Flammable liquid and vapour

SECTION 2: Hazards identification

2.1 Classification of the substance or mixture

Flammable liquids Category 3 Reproductive toxicity Category 18 Specific target organ toxicity Category 3 (Narcotic effects.) - single exposure

Signal word

Warning

Physical hazards

H226 Flammable liquid and vapour HEAL TH HAZARDS: H336 May cause drowsiness or dizziness H360 May damage fertility or the unborn child

Environmental hazards

Not classified as an environmental hazard under GHS criteria

Prevention

P201 Obtain special instructions before use P210 Keep away from heat/sparks/open flames/hot surfaces. - No smoking. P233 Keep container tightly closed. P240 Ground/bond container and receiving equipment. P241 Use explosion-proof electrical/ ventilating/ lighting/ equip­ ment. P242 Use only non-sparking tools. P243 Take precautionary measures against static discharge. P261 Avoid breathing dust/ fume/ gas/ mist/ vapours/ spray. P271 Use only outdoors or in a well-ventilated area. P280 Wear protective gloves/ eye protection/ face protection.

Response

P308 + P313 IF exposed or concerned: get medical advice P303 + P361 + P353 IF ON SKIN (or hair): Remove/ Take off immediately all contaminated clothing. Rinse skin with water/ shower. P304 + P340 IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing. P312 Call a POISON CENTER or doctor/ physician if you feel unwell. P370+P378 In case of fire: Use appropriate media for extinction.

Storage

P403 + P235 Store in a well-ventilated place. Keep cool. P405 Store locked up.

Disposal

P501 Dispose of contents and container to appropriate waste site or reclaimer in accordance with local and national regula­ tions.

Other hazards which do not result in classification

Vapours are heavier than air. Vapours may travel across the ground and reach remote ignition sources causing a flashback fire danger. Even with proper grounding and bonding, this material can still accumulate an electrostatic charge. If sufficient charge is allowed to accumulate, electrostatic discharge and ignition of flammable air­ vapour mixtures can occur.