116DA SILICONE SPRAY LUBRICANT 10.2502 AE

SECTION 2: Hazards identification

This chemical is considered hazardous by the 2012 OSHA Hazard Communication Standard (29 CFR 1910.1200) _ Classification

2.2 Label elements

Emergency Overview Danger jay be fatal if swallowed and enters airways xtremely flammable aerosol ontains gas under pressure; may explode if heated 10.250Z AE inhalation IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing. If symptoms persist, call a physician. ingestion \F SWALLOWED.:. Call a physician or poison control center immediately. Do NOT induce vamiting. Self-protection of the first alder Use personal protective equipment as required. Avoid contact with skin, eyes or clothing. Most important symptoms and effects, both acute and delayed Symptoms See section 2 for more information. Indication of any immediate medical attention and special treatment needed Note to physicians Treat symptomatically. 5. FIRE-FIGHTING MEASURES | Suitable extinguishing media Carbon dioxide (CO2), Dry chemical, Foam Unsuitable extinguishing media None. Specific hazards arising from the chemical Extremely flammable. Heating causes rise in pressure with risk of bursting. Explosion data Sensitivity to Mechanical Impact None. Sensitivity to Static Discharge None. Protective equipment and precautions for firefighters As in any fire, wear self-contained breathing apparatus pressure-demand, MSHA/NIOSH (approved or equivatent) and full protective gear. 6. ACCIDENTAL RELEASE MEASURES ig i Personal precautions, protective equipment and emergency procedures Personal precautions Ensure adequate ventilation, especially in confined areas, Avoid contact with eyes and skin. Use personal protective equipment as required. Environmental precautions Do not flush into surface water or sanitary sewer system. See Sectian 12 for additional ecological information. Methods and material for containment and cieaning up Methods for containment Prevent further leakage or spillage if safe to do so. Methods for cleaning up Eliminate all ignition sources if safe to do so. Ensure adequate ventilation. Soak up with inert absorbent material. Sweep up and shovel into suitable containers for disposal. Prevention of secondary hazards Clean contaminated objects and areas thoroughly observing environmental regulations. T.HANDLINGANDSTORAGE | Precautions for safe handling 10.2502 AE Flash point No information available Gives a flame projection at full valve opening or flashback at any degree of valve opening Evaporation rate <4 Butyl acetate = 1 Flammability (solid, gas) No information available Flammability Limit in Air Upper flammability limit: No information available Lower flammability limit: No information available Vapor pressure No information available Vapor density >4 Air= 1 Relative density 0.94 Water solubility No information available Solubility in other solvents No information available Partition coefficient No information available Autoignition temperature No information available Decomposition temperature No information available Kinematic viscosity No information available Dynamic viscosity No information available Explosive properties No information available Oxidizing properties No information available

2.1 Classification of the substance or mixture

OSHA Regulatory Status This chemical is considered hazardous by the 2012 OSHA Hazard Communication Standard (29 CFR 1910.1200) Aspiration toxicity Category 1 Flammable aerosols Category 1 [Gases under pressure Liquefied gas