Note: Ingredients listed on restricted chemical lists
EC/CAS
9016-87-9
Name of the chemical
4,4'-Methylendiphenyldiisocyanat tech. (Polymeres) MDI, pMDI (in Form atembarer Aerosole, A-Fraktion)
Concentration
30-60
EC/CAS
101-68-8
Name of the chemical
4,4’-Methylenediphenyl diisocyanate
Concentration
15-40
EC/CAS
26447-40-5
Name of the chemical
Methylenediphenyl diisocyanate (see also specific isomers)
Concentration
7-13
General Information
Revision date
2020-06-01
Product name
EVERCOAT FOAM-IT TWO PART
1.2.1 Relevant identified uses
Liquid Foam Base A-side. Component for 2-part polyurethane systems. For professional use only
Emergency telephone
1-800-424-9300, 1-703-527-3887
Icons in SDS
Company Information
company name
ITW Evercoat
e-mail address of the competent person responsible for the Safety Data Sheet
Info@evercoat.com
GHS Information
Signal word
Danger
Section 2
SECTION 2: Hazards identification
This chemical is considered hazardous by the 2012 OSHA Hazard Communication Standard (29 CFR 1910.1200) Classification
Signal word
Danger Harmful if inhaled Causes skin irritation Causes serious eye irritation May cause allergy or asthma symptoms or breathing difficulties if inhaled May cause an allergic skin reaction Suspected of causing cancer May cause respiratory irritation May cause damage to organs through prolonged or repeated exposure Appearance Amber Physical state Liquid Odor Aromatic Precautionary Statements - Prevention Obtain special instructions before use Do not handle until all safety precautions have been read and understood Use personal protective equipment as required Use only outdoors or in a well-ventilated area Wash face, hands and any exposed skin thoroughly after handling In case of inadequate ventilation wear respiratory protection Contaminated work clothing should not be allowed out of the workplace Wear protective gloves Do not breathe dust/fume/gas/mist/vapors/spray Precautionary Statements - Response IF exposed or concerned: Get medical advice/attention Specific treatment (see .? on this label) IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing If eye irritation persists: Get medical advice/attention IF ON SKIN: Wash with plenty of soap and water Take off contaminated clothing and wash before reuse If skin irritation or rash occurs: Get medical advice/attention IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing If experiencing respiratory symptoms: Call a POISON CENTER or doctor/physician Precautionary Statements - Storage Store locked up Store in a well-ventilated place. Keep container tightly closed
Precautionary statements
Disposal Dispose of contents/container to an approved waste disposal plant
2.3 Other hazards
Not applicable
Further information
Not applicable.
2.1 Classification of the substance or mixture
OSHA Regulatory Status This chemical is considered hazardous by the 2012 OSHA Hazard Communication Standard (29 CFR 1910.1200) Acute toxicity - Inhalation (Dusts/Mists) Category 4 Skin corrosion/irritation Category 2 Serious eye damage/eye irritation Category 2 Respiratory sensitization Category 1 Skin sensitization Category 1 Carcinogenicity Category 2 Specific target organ toxicity (single exposure) Category 3 Specific target organ toxicity (repeated exposure)