ET

Further information

No information

Principle Routes of Exposure

INHALATION, SKIN CONTACT, EYE CONTACT, INGESTION SECTION 4— FIRST AID MEASURES EYE CONTACT: Immediately flush eyes with plenty of water for at least 15 minutes. Get immediate medical attention. SKIN CONTACT: For hot product, immediately immerse in or flush the affected area with large amounts of cold water to dissipate heat. Cover with clean cotton sheeting or gauze and get prompt medical attention. No attempt should be made to remove material from skin or to remove contaminated clothing as the damaged flesh can be easily torn. For cold material: treat symptomatically. INHALATION: No specific treatment is necessary since this material is not likely to be hazardous by inhalation. If exposed to excessive levels of dusts or fumes, remove to fresh air and get medical attention if cough or other symptoms develop. INGESTION: Swallowing less than an ounce will not cause significant harm. For larger amounts, do not induce vomiting, but give one or two glasses of water to drink and get medical attention. NOTES TO PHYSICIAN: Treat symptomatically. Page 2 of 6 ECTION' 5: = FIRE FIGHTING MEASURES FLASH POINT: >300F PENSKY-MARTENS C.C. ) LOWER EXPLOSIVE LIMIT: N.A. UPPER EXPLOSIVE LIMIT: N.A. AUTOIGNITION TEMPERATURE: No data EXTINGUISHING MEDIA: ALCOHOL FOAM, FOAM, DRY CHEMICAL, CO2, WATER FOG UNUSUAL FIRE AND EXPLOSION HAZARDS: Finely divided dust in air may present explosion hazard. Prevent dust buildup. SPECIAL FIREFIGHTING PROCEDURES: Treat as petroleum fire. Wear appropriate approved protective equipment. Avoid directing water stream directly into flame; it may cause frothing with subsequent spread of flame SECTION 6 = ACCIDENTAL RELEASE MEASURES “STEDS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Reclaim clean material. Contaminated material should be swept or shoveled into appropriate waste container and disposed of in accordance with applicable federal, state and local regulations. HANDLING: ‘Wash thoroughly after handling. Minimize dust generation and a accumulation. Avoid breathing dust, vapor, mist or gas. DO NOT take internally. FOR INDUSTRIAL USE ONLY.

Storage

Keep away from heat and flame SECTION 8 = EXPOSURE. CONTROLS/PERSONAL PRO ENGINEERING CONTROLS: General ventilation usually adequate. RESPIRATORY PROTECTION: None normally required under general ventilation. SKIN PROTECTION: Clean clothing to cover skin. Thermal gloves when handling hot material. EYE PROTECTION: Safety glasses. OTHER PROTECTIVE EQUIPMENT: Accessible eye wash and safety shower. HYGIENIC PRACTICES: Follow good general industrial safety practices during use. Do not smoke or eat during use. HYSICAL AND CHEMICAL PROPERTIES BOILING RANGE: 390-500F VAPOR DENSITY: Ig heavier than air ODOR: Faint phenolic ODOR THRESHOLD: N.A. APPEARANCE: Black EVAPORATION RATE: Is slower than Buty! Acetate SOLUBILITY IN H20: Insoluble FREEZE POINT: NLA. SPECIFIC GRAVITY: 2.0931 VAPOR PRESSURE: N.A. pH @ 0.0%: N.A. PHYSICAL STATE: Solid VISCOSITY: N.A. COEFFICIENT OF WATER/OIL DISTRIBUTION: No Data _ ' (SEE SECTION 16. FOR ABBREVIATION LEGEND) :” Page 3 of 6 “CONDITIONS TO AVOID: No information. INCOMPATIBILITY: Strong Lewis or mineral acids. Strong bases or oxidants. HAZARDOUS DECOMPOSITION PRODUCTS: Oxides of carbon. Oxides of nitrogen, ammonia. Aromatic and aliphatic hydrocarbons. Aldehydes and acids from incomplete combustion. Phenolic compounds. In the presence of nascent hydrogen, highly toxic stibine gas may be envolved. HAZARDOUS POLYMERIZATION: Will not occur under normal conditions. STABILITY: This product is stable under normal storage conditions. SECTION 11— TOXICOLOGICAL PROPERTIES. SSMPONENT TOMIGOLOGICAL INEGRMATION: sereeeeee> CHEMICAL NAME ----------- -——-— LD50 ------ ------ LC50 ------ 2,4,6-Tri(dimethylaminomethyl) Phenol derm(rat)1280mg/kg No information Epoxy resin Oral-rat=>11 g/kg No deaths/satd air Carbon Black Oral-rat=>8 g/kg No information Silicon dioxide (quartz) No information Antimony trioxide No information

ECOLOGICAL INFORMATION

ECOLOGICAL TEST DATA: No information. “SECTION 13 = DISPOSAL CONSIDERATIONS | DISPOSAL METHOD: Material as sold may be disposed of in landfill if local regulations permit. 7 material becomes contaminated, follow disposal instructions for contaminant. ~ SECTION 14 = TRANSPORTATION INFORMATION... ‘DOT PROPER SHIPPING NAME: Not regulated DOT TECHNICAL NAME: N.A. DOT HAZARD CLASS: N.A. HAZARD SUBCLASS: N.A. DOT UN/NA CLASS: N.A. PACKAGING GROUP: N.A. RESP. GUIDE PAGE: INTERNATIONAL SHIPPING NAME: Not regulated INTERNATIONAL ID NUMBER: N.A. IMDG CLASS (1°, 2°): N.A. IMDG PAGE NUMBER: N.A. IMDG EMS: N.A. IATA CLASS (1°, 2°): NLA. Page 4 of 6 “SECTION:15 = REGULATORY. INFORMATION... *| OSHA: Hazardous by definition of Hazard Communication Standard (29 CFR 1910.1200) CERCLA — SARA HAZARD CATEGORY: THIS PRODUCT HAS BEEN REVIEWED, AND IS CONSIDERED, UNDER APPLICABLE DEFINITIONS, TO MEET THE FOLLOWING CATEGORIES: IMMEDIATE HEALTH HAZARD CHRONIC HEALTH HAZARD SARA SECTION 313: THIS PRODUCT CONTAINS THE FOLLOWING SUBSTANCES SUBJECT TO THE REPORTING REQUIREMENTS OF SECTION 313 AND 40 CFR PART 372: ----------- CHEMICAL NAME -------- -- CAS NUMBER WTMT % IS LESS THAN Antimony trioxide 1309-64-4 1.0-5.0 TOXIC SUBSTANCE CONTROL ACT: THE CHEMICAL SUBSTANCES IN THIS PRODUCT ARE ON THE TSCA SECTION 8 INVENTORY. THIS PRODUCT CONTAINS THE FOLLOWING CHEMICAL SUBSTANCES SUBJECT TO THE REPORTING REQUIREMENTS OF TSCA 12(B) IF EXPORTED FROM THE UNITED STATES: --—--—-- —- CHEMICAL NAME CAS NUMBER Fused amorphous silicon dioxide 60676-86-0 NEW JERSEY RIGHT-TO-KNOW: THE FOLLOWING MATERIALS ARE NON-HAZARDOUS, BUT ARE AMONG THE TOP 5 COMPONENTS IN THIS PRODUCT: s-----ee-e> CHEMICAL NAME ----------- CAS NUMBER Fused amorphous silicon dioxide 60676-86-0 PENNSYLVANIA RIGHT-TO-KNOW: THE FOLLOWING NON-HAZARDOUS INGREDIENTS ARE PRESENT IN THE PRODUCT AT GREATER THAN 3%: CALIFORNIA PROPOSTION 65: CANADIAN WHMIS: THIS MSDS HAS BEEN PREPARED IN COMPLIANCE WITH CONTROLLED PRODUCT REGULATIONS EXCEPT FOR USE OF THE 16 HEADINGS. CANADIAN WHMIS CLASS: D2B CANADIAN DSL/NDSL STATUS: The components of this product are on the DSL. COMPONENT RCRA CLASSIFICATIONS: Not regulated COMPONENT RCRA CODES: No information. CERCLA RQ VALUE (MINIMUM): None known Page 5 of 6 HMIS RATINGS HEALTH: 1 FLAMMABILITY: 1 REACTIVITY: 0 PREVIOUS MSDS REVISION DATE: 11/15/05; 15 Nov 2005 REASON FOR REVISION: Administrative change for new format. VOLATILE ORGANIC COMPOUNDS: 0 grams/ltr LEGEND: N.A. - NO INFORMATION N.E. - NOT ESTABLISHED N.D. - NOT DETERMINED ABBREVIATIONS: ACGIH = AMERICAN CONFERENCE OF GOVERNMENTAL INDUSTRIAL HYGIENISTS; OSHA = OCCUPATIONAL HEALTH AND SAFETY ADMINISTRATION; TLV-TWA = THRESHOLD LIMIT VALUE — TIME WEIGHTED AVERAGE (8 HOURS); STEL = SHORT-TERM EXPOSURE LIMIT (15 MINUTES); C = CEILING VALUE; PEL = PERMISSIBLE EXPOSURE LIMIT DISCLAIMER: TO THE BEST OF OUR KNOWLEDGE, THE INFORMATION CONTAINED IN THIS MSDS IS ACCURATE OR IS OBTAINED FROM SOURCES BELIEVED TO BE ACCURATE. HOWEVER, NO LIABILITY, EXPRESSED OR IMPLIED, IS ASSUMED FOR THE ACCURACY OR COMPLETENESS OF THE INFORMATION CONTAINED HEREIN. BUYER ASSUMES LIABILITY IN ITS USE OF THE MATERIAL. Page 6 of 6