Ultra-X Closer Fluid

Hazardous Ingredients

OSHA Hazards Ingredient Name CAS Number Percent TSCA Light naphthenic hydrotreated 64742-53-6 40 - 70 Y distillates (petroleum) HMIS Health: 1 Fire:1 Reactivity:0 PPI: eel Light naphthenic distillate 64742-53-6 15 - 40 Y HMIS Health: 0 Fire:2 Reactivity:0 PPI: Additional Comments: These ingredients are considered to be hazardous products under the

Acute Health Hazards

EFFECTS OF OVEREXFOSURE: EYES; May cause mild eye irritation redneas, tearing, blurred vision. SKIN: Prolonged or repeated contact can cause moderate irritation, defatting, dermatitis. ee —s—e ew eee oe eee ee eee ee =e ee mea - - wane - wn wwe FERB-2H-26GS 13:46 LCN CLOSES — ENG. ais e7o 1495 P,@4 ocT. 16 °02 (FRI) 12:58 PAGE. 4/6 . MATERIAL SAFETY DATA SHEET MSDS Name: Ultra-X Closer Fluid Product Code: ULTRA-X Suffix Number 0001 Msds revision date 10-18-02 Page Number: 3 of 5 BREATHING: Excessive inhalation of vapors and/or spraymiat can cause reapiratory irritation, dizziness, weakness, fatigue, nausea, headache, unconsciousness and even asphyxiation. SWALLOWING: Can cause gastrointestinal irritation, nausea, vomiting and diarrhea. Aspiration of material into the lungs can cause chemical pneumonitia which can be fatal. FIRST AID: EYES: Flush with large amounts of water lifting eyelida occasionally. Get prompt medical attention. SKIN: Wash thoroughly with soap and water. Remove contaminated clothing promptiy. Wash clothing before reuse. BREATHING: Move affected person ta fresh air. If breathing is difficult, administer oxygen. If breathing hae stopped, give artificial respiration. Keep person warm, quiet and get medical attention. SWALLOWING; DO NOT induce vomiting! Keep person warm, quiet and get medical attention. Aspiration of material into the lungs due to vomiting can cause chemical pneumonitia which can be fatal. SECTION 6 - REACTIVITY DATA Stability: This product is atable Hazardous Polymerization: Hazardous polymerization will not occur INCOMPATIBILITY Avoid contact with strong oxidizera (e.g. nitric acid). CONDITIONS TO AVOID: Keep away from heat and open flame. HAZARDOUS DECOMPOSITION PRODUCTS: May form carbon monoxide, carbon dioxide, various hydrocarbons, etc. SECTION 7 - SPILL -OR LEAK PROCEDURES eee ee eee eee ee me mee ee ee em ewe wet ee ee mm eee ee ee oe oe mee ee ewe ee - mawewe mem FEB-28-28835 13:48 LCN CLOSES - ENG. SiS ero idss P.8S OcT.18 '02 (FRI) 12:58 PAGE, 5/6 * MATERIAL SAFETY DATA SHEET MSDS Name: Ultra-X Closer Fluid Product Code: ULTRA-X Suffix Number o00ol os MSDS Revision Date: 10-18-02 Page Number: - €40o0f 5 ee mt ee eee ee ee ne eee we me ee me ee oe we we we oe me - eee me om ew ee ae te ee et nt ew ne oe eat ewe ee ee me ewe STEPS TO BE TAXEN IN CASE MATERIAL IS RELEASED OR SPILLED SMALL SPILL: Keep away from ignition sources (electrical, hot surfaces, etc.). Pick up spill with absorbent material. LARGE SPILL: Contain apill to avoid entry into drains, sewere or waterways. Ventilate and keep traffic from area. Remove with absorbent material (or flush or vacuum) to closed container. WASTE DISPOSAL METHOD: Recovered material should be packaged, labeled, transported, disposed of or reclaimed in compliance with applicable laws and regulations and in conformance with good safety and engineering practicea. Reclaim where possible, SECTION 8 - EXPOSURE CONTROLS/PERSONAL PROTECTION Occupational Exposure Limits ACGIH TLV ACGIH TLV-C ACGIH STEL OBHA STEL OSHA PEL Light naphthenic hydrotreated dietillatea (petroleum) 5.00 mg/M3 N/est N/esat N/eat 5.00 ma/M3 Light naphthenic distillate 5.00 mg/M3 N/est N/eat N/est 5.00 mg/M3 PERMISSIBLE EXPOSURE LEVEL: Observe ACGIH TLV of 5 mg/m3 for oil mists. RESPIRATORY PROTECTION: If the TLV of the product ia exceeded, a NIOSH approved respirator is advised in absence of proper environmental control. Engineering or administrative controls should be implemented to reduce exposure. Select respirators based on form and concentration of contaminant in air. Adhere to 29 CFR 1910,.134. VENTILATION: Provide sufficient mechanical (general and/or local exhaust) ventilation to maintain exposure below TLV. PROTECTIVE GLOVES: Chemical/solvent resistant for prolonged contact. EYE PROTECTION: Chemical splash goggles in compliance with OSHA regulations are advised (consult your safety equipment supplier). OTHER PROTECTIVE EQUIPMENT: Boots, aprons, chemical resistant suite where deemed necessary to avoid contact during prolonged expoaure. wm me mew em ee mewn eww mee wee ew ee ee eel FEB-24-2603 13:49 LCN CLOSES — ENG. 215 879 1495 P.66 ocT. 18 ‘02 (FRI) 12:54 PAGE. 6/6 . MATERIAL SAFETY DATA SHEET MSDS Name: Ultra-X Closer Fluid. Product Code: ULTRA-X Suffix Number OOoL MSDS Revision Date: 10-18-02 Page Number: 5 of 5 ce ame mm eee ae oe meme meme we eee oe ee ee omen oe eee a ee ew ee ee ee eee ee em my oe a ee SECTION 9 - SPECIAL PRECAUTIONS