Intex EziBase Premium Jointing Compound

Intex Group International Pty Ltd

SDS Library

Move your SDS library online today

Check Icon
Setup – Easy setup with our database of 16 million+ SDSs
Check Icon
Up-to-date – Your SDS get updated to latest versions.
Check Icon
Employee access – Tablets, Smartphones, or link from Corporate Intranet
Check Icon
Safety – One-click access to first aid information.
Check Icon
Labels – Generate Secondary Container Labels with just one click.
GHS08
Health risk rating 5
Safety risk rating 1
Environmental risk rating 1

Note: Ingredients listed on restricted chemical lists

EC/CAS

12001-26-2

Name of the chemical

mica

Concentration

0-6 0-5

General Information

Product name

Intex EziBase Premium Jointing Compound

Product Synonyms

Stopping Compound, Stopping Mix or Mud, Joint Taping Compound

1.2.1 Relevant identified uses

Safety & Handling: Base and second coats in plasterboard jointing, installing plaster cove and cornice, rendering, industrial Wash hands with soap and water after use. Do not swallow. Avoid contact with eyes ™

supplier name

By

Manufacturer Name

Intex International

Emergency telephone

+61 3 9357 9299

Icons in SDS

GHS08

Company Information

company name

Intex Group International Pty Ltd

GHS Information

Signal word

Danger

Hazard Codes

Hazard statements (CLP)

H350, H373

Hazard statements

Code

Statements

H350

May cause cancer

H373

May cause damage to organs through prolonged or repeated exposure

Section 2

SECTION 2: Hazards identification

GHS Classification 10. Allow to dry for approximately 24 hours.

2.1 Classification of the substance or mixture

Setting compounds and plasters are not classified as Dangerous Good for Transport. 11. Lightly sand in the same direction as the joint using 220 grit, or finer, sand paper. Take care not to scuff the face paper of the plasterboard. WARNING DANGER Causes skin irritation. Limitations May cause cancer. Causes serious eye irritation. May cause respiratory irritation. Harmful if inhaled. Compound plasterboard. Intex EziBase™ Jointing compounds are specifically formulated and tested for use on Used for the first & second coats in a three coat drywall jointing system - Water, air and surface temperatures above 10°C should be maintained until Setting compounds and plasters are not classified as Dangerous Good for Transport. compound is completely dry. - During winter periods or under cold damp conditions, drying rates can be improved HSNO Approval Number: HSR002545 - 60 min setting time by using more, but thinner coats of compound. shrinkage and possible decontamination. Carcinogen – Category 1A. Systemic Target Organ Toxicant, repeated exposure – Category 2. - Easy to trowel and feather edge - Do not use for laminating plasterboard or fixing cornice.

HSNO Classifications

6.7A May cause cancer by inhalation. 6.9B Harmful to human target organs or systems. - Superior tape adhesion & joint strength CBB2060R SDS - Do not apply over air drying compounds as this can lead to problems with delayed

Hazard statements

Low Shrinkage H350 May cause cancer (inhalation). H373 May cause damage. - Do not use for the finish coat or skim coating. - Evaporated or absorbed water loss from the mixed and applied Intex EziBase™ can 60 be excessive in hot dry conditions (air and/or substrate temperatures above 25°C)

SDS Library

Move your SDS library online today

Check Icon
Setup – Easy setup with our database of 16 million+ SDSs
Check Icon
Up-to-date – Your SDS get updated to latest versions.
Check Icon
Employee access – Tablets, Smartphones, or link from Corporate Intranet
Check Icon
Safety – One-click access to first aid information.
Check Icon
Labels – Generate Secondary Container Labels with just one click.