Note: Ingredients listed on restricted chemical lists
EC/CAS
14807-96-6
Name of the chemical
Talc
Concentration
<5
EC/CAS
24937-78-8
Name of the chemical
ethylene-vinyl acetate copolymer wax
Concentration
<5
EC/CAS
108-05-4
Name of the chemical
Vinylacetat (944/2013)
Concentration
<5
General Information
Revision date
2020-04-23
Product name
ProForm - Ultra Lite, ProForm - Lite Blue
Product Synonyms
Joint Compound, Taping Compound, Gypsum Board Finishing Compound
1.2.1 Relevant identified uses
All-purpose drying-type compounds used for finishing gypsum board products. Use per manufacturer’s recommendations
1.2.2. Uses advised against
Use in well-ventilated area and avoid breathing dust Intex Group International Pty Ltd (ACN 163012039) 115 McKellar Way Epping, Victoria, Australia 3076 +61 3 9357 9299 (or 1300 107 108 within Australia) Intex New Zealand Pty Ltd (NZCN 7388136) 13 Mahunga Drive, Mangere Bridge, Auckland 2022, New Zealand
supplier name
13 11 26 (AU Poisons Info Centre)
Manufacturer Name
64 6 377 7255 (or 0800 278 276 within New Zealand)
Icons in SDS
Company Information
company name
Intex Group International Pty Ltd
GHS Information
Signal word
2_2_5_HAZARD_STATEMENTS
Hazard Codes
Hazard statements (CLP)
H315, H332, H350, H372
Hazard statements
Code
Statements
H315
Causes skin irritation
Section 2
SECTION 2: Hazards identification
(29 CFR 1910.1200) United States (US)
Hazard pictograms
DANGER WARNING CAUTION May cause cancer. Causes skin irritation. Two person lift. Harmful if inhaled. May cause respiratory irritation.
Hazard statements
H-350: H-332, 372 May cause cancer. Harmful if inhaled. Causes damage to organs (lungs) through prolonged or repeated exposure. H-315 Causes skin corrosion/irritation.
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Do not breathe dust. Use personal protective equipment as required. (See Section 8) Use engineering controls and wet methods to minimize dust. If breathing is difficult, remove victim to fresh air and keep at rest in a position comfortable for breathing. If on skin, wash with
Response
plenty of soap and water. If in eyes, rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Get medical attention if exposed or concerned.
Storage
Store material in a cool, dry, ventilated area, away from excessive heat or sunlight.
Disposal
Dispose of material in accordance with federal, state, and local regulations. © 2026 Intex International Pty Ltd. 1
2.1 Classification of the substance or mixture
Specific target organ toxicity, repeated exposure – Category 1 (H-372). substance or mixture: Acute toxicity, inhalation - Category 4 (H-332). Skin corrosion/irritation Category 2 (H315).
