General Pump Oi-AW-100

Hazard statements (CLP)

H227

Code

Statements

H227

Combustible liquid

SECTION 2: Hazards identification

WARNING: - MAY CAUSE EYE IRRITATION - MAY CAUSE SKIN IRRITATION Eye contact: Direct contact may cause irritation, redness, tearing and blurred vision. Skin contact: Avoid prolonged skin contact. This product contains materials that may cause skin irritation. Prolonged or repeated contact may result in dermatitis (dryness, chapping and reddening of skin). inhalation: Overexposure by inhalation of hot material may cause nonspecific discomfort, such as nausea, headache, or weakness. Caution should be taken to prevent aerosolization or misting of this product without proper respiratory protection. ingestion: Do not ingest. Product is expected to be relatively non-toxic unless lung aspiration occurs. Aspiration is not expected with this material due to heavy viscosity. Should aspiration occur, may lead to chemical pneumonitis which is characterized by pulmonary edema and hemorrhage and may be fatal. Signs of lung involvement include increased respiratory rate, increased heart rate, and a biuish discolorization of the skin. Coughing, choking and gagging are often noted at the time of aspiration. This product has laxative properties and may result in abdominal cramps and diarrhea. Other: Not applicable. FIRST AID MEASURES Eye contact: Flush iramediately with large amounts of water for at least 15 minutes. Eyelids should be held away from the eyeball to ensure thorough rinsing. Get medical attention if irritation persists. If material is hot, treat for thermal burns and take GENERAL PUMP «+ MSDS Series 100 Oil » PAGE 1 of 6 victim to hospital immediately. Skin contact: Remove contaminated clothing. Wash contaminated area thoroughly with soap and water. If redness or irritation occurs, seek medical attention. If material is hot, submerge injured area in cold water. If victim is severely burned, remove To a hospital immediately. Wash contaminated clothing before reuse. Inhalation: if overcome by inhilation of hot vapors, remove to fresh air. Use oxygen if there is difficulty breathing or artificial respiration if breathing has stopped. Do not leave victim unattended. Seek immediate medical attention if necessary. Ingestion: Do not induce vomiting because of danger of aspirating liquid into lungs, causing serious damage and chemical pneumonitis. If spontaneous vomiting occurs keep head below hips to prevent aspiration and monitor for breathing difficulty, Gastric lavage should be performed only by qualified medical personnel. Keep affected person warm and at rest. Seek immediate attention. Other: Not applicable. FIRE FIGHTING MEASURES Flash point: 204° C (400°F) ASTM D-92 Flammable iimits: Not determined. Extinguishing media: Use water spray, dry chemical, alcohol foam, all purpose AFFF or carbon diexide to extinguish fire. Special firefighting procedures: Evacuate area and fight fire from a safe distance. If leak or spill has not ignited, ventilate area and use water spray to disperse gas or vapor and to protect Ra personnel attempting to stop a leak. Use water spray to cool adjacent structures and to protect personnel. Shut off source of flow if possible (safely). Stay away from

Storage

tank ends. Withdraw immediaiely in case of rising sound from venting safety device or any discoloration of storage tank due to fire. Fire fighters must wear MSHA/NIOSH approved positive pressure breathing apparatus (SCBA) with full face mask and full protective equipment. Unusual fire & explosion hazards: Dense smoke may be generated while burning. Toxic fumes, gases or vapors may evolve on burning. Heavy flammable vapors may settle along ground level and low spots to create an invisible fire hazard. The vapors may extend to sources of ignition and flash back. Byproducts of combustion: Fires involving this product may release oxides of carbon, nitrogen, sulfur, phosphorous; reactive hydrocarbons and irritating vapors. Autoignition temperature: Not determined. Explosion data: Not determined. Other: Not applicable. ACCIDENTAL RELEASE MEASURES Spill control procedures (land): immediately turn off cr isolate any source of ignition (pilot lights, electrical equipment, flames, heaters, etc.). Evacuate area and ventilate. Personnel wearing proper protective equipment should contain spill immediately with inert materials (sand, earth, chemical spill pads of cotton) by forming dikes. Dikes should be placed to contain spill in a manner that will prevent material from entering sewers and waterways. Large spill, once contained, may be picked up using explosion proof, non-sparking vacuum pumps, shovels, or buckets, and disposed of in suitable containers for disposal. If a large spill occurs notify appropriate authorities. Spill control procedures (water): Remove from surface by skimming or with suitable absorbents. If a large spill occurs notify appropriate authorities (normally the National Response Center or GENERAL PUMP «+ MSDS Series 100 Oil + PAGE 2 of 6 Coast Guard). Waste disposal method: Most oil based products are incinerated, land-filled or reclaimed. All disosals must comply with federal, state, and local regulations. The material, if spilled or discarded may be a regulated waste. Refer to state and local regulations. Department of Transportation (DOT) regulations may apply for transporting this material when spilled. See section 14. Other: CAUTION - If spilled material is cleaned up using a regulated solvent, the resulting waste mixture will be regulated. HANDLING AND STORAGE Handling Procedures: Keep containers closed when not in use. Do not transfer to unmarked containers. Fire extinguishers should be kept readily available. See NFPA 30

Additional information

No additional information. EXPOSURE CONTROLS / PERSONAL PROTECTION Personal protection: Applicable mainly to persons In repeated contact situations such as packaging of product, service/maintenance, and cleanup/spill control personnel. Respiratory protection: None required if airborne concentrations are maintained below threshold limits