General Information
Revision date
2004-11-01
Product name
Zinc Metal Reagent Grade, Powder (dust)
Product Synonyms
NA = Not Applicable NE = Not Established
CAS No.
7740-66-6
Icons in SDS
Company Information
company name
Impact Environmental Consulting, Inc.
GHS Information
Signal word
danger
Section 2
SECTION 2: Hazards identification
Also see section 11) OSHA Keep away from heat and ignition sources. Harmful if swallowed. Avoid breathing vapors. Use with adequate ventilation. Avoid contact with eyes, skin, and clothes. Wash thoroughly after handling. Keep container closed. Section 4 First Aid Measures Keep away from heat and ignition sources. Harmful if swallowed. Avoid breathing vapors. Use with adequate ventilation. Avoid contact with eyes, skin, and clothes. Wash thoroughly after handling. Keep container closed. FIRST AID CALL A PHYSICIAN. SKIN Wash exposed area with soap and water EYES Wash eyes with plenty of water for at least 15 minutes, lifting lids occasionally. Seek Medical Aid. INHALATION Remove to fresh air If not breathing, give artificial respiration. If breathing is difficult, give oxygen INGESTION: If swallowed, induce vomiting immediately after giving two glasses of water. Never give anything by mouth to an unconcious person. Section 5 Fire Fighting Measures Fire Extinguisher Type Smother with dry powder (i.e. sand, sodium chloride, magnesium oxide) Dust, in moist air can generate sufficient heat to ignite the hydrogen gas released. Metal burns at high Fire/Explosion Hazards: tempuratures. 41 Fire Fighting Avoid water. Wear self-contained breathing apparatus and protective clothing to prevent contact with skin and Procedure: clothing. Section 6 Accidental Release Measures Avoid water. Remove all sources of ignition. Ventilate area of leak or spill. Wear respiratory protection. Do not disperse dust into air. Use non-sparking tools to pick up and place in closed dry container. Section 7 Handling and Storage Store in a cool, dry, well-ventilated place away from incompatible materials. Wash thoroughly after handling. Section 8 Exposure Controls & Personal Protection Respiratory Protection:NIOSH/MSHA-approved respirator Hand Protection: NIOSH Approved Gloves Mechanical: Ventilation: Eye Protection: Safety Glasses Local Exhaust: Other Protective Equipment: Use safe laboratory handling procedures. Section 9 Physical and Chemical Properties Melting Point: 419° C Specific Gravity 7.14 Boiling Point: 907° C Percent Volatile by Volume: N/A Vapor Pressure: N/A Evaporation Rate: N/A Vapor Density: N/A Evaporation Standard: Solubility in Water: Not soluble Auto ignition Temperature: 460° C
Appearance/Odor
Gray, blue matallic powder / no odor Lower Flamm. Limit in Air N/E Flash Point: information not available Upper Flamm. Limit in Air: N/E Section 10 Stability and Reactivity Information Stability: Stable Conditions to Avoid: Heat and moisture Materials to Avoid: Hazardous Decomposition Products: Hydrogen gas, Zinc oxide fumes Hazardous Polymerization:Will Not Occur Condition to Avoid:None known
Additional information
Conditions aggravated/Target organs Persons with preexisting skin or respiratory disorders may be more susceptible. Acute Irritation possible to skin, eyes, lungs, mucous membranes, and GI tract. If heated fumes may cause "zinc fume fever". Chronic: None known. DOT Classification: Zinc Dust, 4.3, UN1436, PG II DOT regulations may change from time to time. Please consult the most recent version of the relevant regulations. Revision No:0 Date: Entered 9/1/2005 Approved by: WPF 42 12.1 Emergency Contact Information In the event of an accident or emergency situation, emergency procedures will be executed. Said procedures can and will be executed by the first person to observe an accident or emergency situation. The Project Field Manager will be notified about the situation immediately after emergency procedures are implemented. 12.1.1 Emergency Contacts Emergency: 911 Hospital: (718) 579-5000 Lincoln Medical Center Police: 911 Police Fire Department: 911 NYFD Chemtrec: 800-424-9300 Poison Control Center: 800-336-6997 National Response Center: 800-424-8802 US EPA (24-hour hotline): 800-424-9346 Driving directions to Lincoln Medical Center 43 12.1.2 Utility Emergencies / Initiating Subsurface Investigation Work Where necessary, utility markouts will be called in via the one call center or to the individual entities listed below. Mark Out One-Call Center 1-800-272-4480 No-Cuts Gas Company: 718-643-4050 Keyspan/Con Edison Telephone Company: 516-661-6000 Bell Atlantic / Verizon Electric Company: 718-643-4050 Keyspan/Con Edison 44 12.2 Contingency / Evacuation Plan This Section is not, nor does it purport to be, a comprehensive recitation of safety and health requirements applicable to emergency procedures. Rather, contractors, subcontractors and workers at the site must refer to OSHA’s Employee Emergency Action Plan Standard, set forth at 29 C.F.R. § 1910 Part 1926.35(a), as well as all supporting OSHA Compliance Directives and Letters of Interpretation, for complete information on safety and health compliance obligations. If an unknown substance or substance container is encountered during site activities, the following contingency plan will be triggered. 1. The Site Health and Safety Officer, Project Manager and Field Operations Leader will be notified and an Exclusion Zone (the aerial extent of which will be determined by the above safety staff) will be established. 2. All staff will be evacuated from the Exclusion Zone. 3. Air monitoring will be conducted down-wind of the Exclusion Zone. 4. The NYSDEC, as well as any other Government regulatory agency whose need may be prompted by the particular situation, will be notified. 5. Upon arrival of the NYSDEC or Government regulatory agency representative(s), site control will transfer to the appropriate Government personnel. It may be possible that a situation could develop site emergency could necessitate the evacuation of all personnel from the site. If such a situation develops, an audible alarm shall be given for site evacuation (consisting of an air horn). Personnel shall evacuate the site in a calm and controlled fashion and regroup at a predetermined location. The route of evacuation will be dependent on wind direction, severity, type of incident, etc. The site must not be re-entered until back-up help, monitoring equipment, and/or personal protective equipment are on hand and the appropriate regulatory agencies have been notified. 12.3 Emergency Medical Treatment Procedures This Section is not, nor does it purport to be, a comprehensive recitation of safety and health requirements applicable to medical treatment and first aid. Rather, contractors, subcontractors and workers at the site must refer to OSHA’s Medical Services and First Aid Standard, set forth at 29 C.F.R. § 1910 Part 1926.23 and 1926.50, as well as all supporting OSHA Compliance Directives and Letters of Interpretation, for complete information on safety and health compliance obligations. All injuries, no matter how slight, will be reported to the site safety supervisor immediately. The safety supervisor will complete an accident report for all incidents (Appendix B). Some injuries, such as severe lacerations or burns, may require immediate treatment. Unless required due to immediate danger seriously injured persons should not be moved without direction from attending medical personnel. 45 12.3.1 Standard Procedures for Injury 1. Notify the Site Health and Safety Officer, Project Manager, and the NYCDEP and NYCDHPD of all accidents, incidents, and near emergency situations. 2. If the injury is minor, trained personnel should proceed to administer appropriate first aid. 3. Telephone for ambulance/medical assistance if necessary. Whenever possible, notify the receiving hospital of the nature of physical injury or chemical overexposure. If no phone is available, transport the person to the nearest hospital. Refer to the map in section 11.2.1. 4. When transporting an injured person to a hospital, bring this Construction Health and Safety Plan with the attached MSDS to assist medical personnel with diagnosis and treatment. 12.3.2 Chemical Overexposure In all cases of chemical overexposure, follow standard procedures as outlined below for poison management, first aid, and, if applicable, cardiopulmonary resuscitation. Different routes of exposure and their respective first aid/poison management procedures are outlined below. Ingestion Do not induce vomiting unless prompted by a health professional. Transport person to nearest hospital immediately. Inhalation / Confined Space Do not enter a confined space to rescue someone who has been overcome unless properly equipped and a standby person present. Inhalation / Other Move the person from the contaminated environment. Initiate CPR if necessary. Call or have someone call for medical assistance. Refer to MSDS for additional specific information. If necessary, transport the victim to the nearest hospital as soon as possible. Skin Contact / Non-Caustic Wash off skin with a large amount of water immediately. Remove any affected Contaminant (Petroleum, clothing and rewash skin using soap, if available. Transport person to a medical Gasoline, etc.) facility if necessary. Skin Contact / Corrosive Wash off skin with a large amount of water immediately. Remove any affected Contaminant (Acids, clothing and rewash skin with water. Transport person to a medical facility if Hydrogen Peroxide, etc.) necessary. Eyes Hold eyelids open and rinse the eyes immediately with large amounts of water for 15 minutes. Never permit the eyes to be rubbed. Transport person to a medical facility as soon as possible. 12.3.3 First Aid for Injuries Incurred During Field Work A first aid kit and an emergency eyewash will be available on-site. Field crews, when performing field operations, will carry portable first aid kits that include emergency eye wash stations. 46 12.3.4 First Aid Equipment List The first aid kit(s) kept at the site will consist of a weatherproof container with individually sealed packages for each type of item. The kit will include at least the following items: • Gauze roller bandages, 1-inch and 2-inch • Gauze compress bandages, 4-inch • Gauze pads, 2-inch • Adhesive tape, 1-inch • Bandage, 1-inch • Butterfly bandages • Triangular bandages, 40-inch • Ampules of ammonia inhalants • Antiseptic applicators or swabs • Burn dressing and sterilized towels • Surgical scissors • Eye dressing • Portable emergency eye wash • Emergency oxygen supply • Alcohol • Hydrogen peroxide • Clinical grade thermometer • Tourniquet 12.3.5 Other Emergency Equipment One portable fire extinguisher with a rating (ratio) of 20 pound A/B/C and one portable fire extinguisher with a rating of 2A will be conspicuously and centrally located between the restricted and non-restricted zones. In addition, similar extinguishers of the same size and class will be located in the site office trailer so that maximum travel distance to the nearest unit shall not exceed 50 feet. Portable extinguishers will be properly tagged with inspection dates and maintained in accordance with standard maintenance procedures for portable fire extinguishers. Field personnel will be trained in fire extinguisher use before field operations begin. An emergency at any part of the site, such as fire or chemical release, might require that some appropriately trained site workers direct traffic on or near the site. The following safety equipment to be used for traffic should be kept readily available on site in the field office: 47 • reflective/fluorescent vests • flares • traffic cones (and flags, or the equivalent, as needed) • hazard tape (barricades as needed) • working flashlights 12.4 Record of Injuries Incurred On-Site 12.4.1 Occupational Injuries and Illnesses Form (OSHA 200) All occupational injuries and illnesses that are required to be recorded under the Occupational Safety and Health Act will be registered on OSHA Form 200 (see Appendix C). The site safety supervisor will record occupational injuries and illnesses within 48 hours of occurrence, as required by statute. 12.4.2 Employer’s First Report of Injury The site safety supervisor for all accidents involving work injury at the site will complete this form (Appendix D). Follow-up procedures will include investigation of each accident or near-miss by the safety supervisor to assure that no similar accidents occur in the future. 48 APPENDIX A Accident Report Form Employee Accident Report EMPLOYEE Name______________________________________SS