STS Tire Sealant

HMIS® ratings

(0-4) Ingredients: CAS 1333-86-4 Carbon Black 1-5 % CAS 10101-89-0 TriSodiumPhosphate (TSP) 1-5 % CAS 9006-04-6 Natural Rubber 1-5 % CAS 2492-26-4 Sodium mercaptobenzothiazole <1 % CAS 111-30-8 Glutaraldehyde <1 % CAS 7631-99-4 Sodium Nitrate <1 % CAS 1314-13-2 Zinc oxide <0.1 % Percentages are by weight Description of first aid measures After inhalation: Not a likely route of exposure. Remove patient from exposure. Keep patient at rest and give oxygen if breathing difficult. If symptoms develop, obtain medical attention. After skin contact: Wash hands and exposed skin with soap and plenty of water. Seek medical attention if irritation persists or if concerned. After eye contact: Protect unexposed eye. Flush exposed eye gently using water for 15-20 minutes. Remove contact lenses while rinsing. Keep eyelids open while rinsing. Seek medical attention. After swallowing: Ingestion is expected to cause irritation of the gastrointestinal tract. If swallowed, seek medical advice immediately and show this container or label. Do not induce vomiting. Make victim drink plenty of water. Most important symptoms and effects, both acute and delayed: Irritation. Indication of any immediate medical attention and special treatment needed: If seeking medical attention provide SDS document to physician. Physician should treat symptomatically. Extinguishing media Suitable extinguishing agents: Use water foam, dry chemical, chemical foam, carbon dioxide, or alcohol- resistant foam. For safety reasons unsuitable extinguishing agents: Direct water stream is not advisable. Special hazards arising from the substance or mixture: Thermal decomposition could possibly lead to release of irritating gases and vapors. Advice for firefighters: Protective equipment: A self-contained breathing apparatus and suitable protective clothing should be worn in fire conditions. Additional information (precautions): None. Personal precautions, protective equipment and emergency procedures: Wear protective eyewear. Environmental precautions: Not applicable Methods and material for containment and cleaning up: Mix spilled product with sand, then shovel up into covered container. For small spills on hard surfaces, allow substance to harden, then scrape up and discard. Reference to other sections: Precautions for safe handling: Avoid contact with eyes. Conditions for safe storage, including any incompatibilities: Store at ambient temperature. Do not Store near heat or open flames. Do not freeze. Control Parameters: No applicable occupational exposure limits. Appropriate Engineering controls: None. Respiratory p r o t e c t i o n Not required under normal conditions of use. Protection of skin: Not required under normal conditions of use. Eye protection: Safety glasses or goggles are appropriate eye protection. General hygienic measures: Wash hands before breaks and immediately after handling the product. Avoid contact with eyes. Appearance (physical Explosion limit lower: Not determined Viscous Black liquid state, color): Explosion limit upper: Not determined Odor: Faint polyol Vapor pressure: Not determined Odor threshold: Not determined Vapor density: Not determined pH-value: 10.0-11.0 Relative density: 1.10-1.13 Melting/Freezing point: (-10°F / -23*C) Solubilities: >90% Boiling point/Boiling Partition coefficient (n- Not determined range: octanol/water): Flash point (open Auto/Self-ignition >300F (149C) Not determined cup): temperature: Decomposition Evaporation rate: Not determined temperature: Flammability Not determined Viscosity: (solid, gaseous): 4200-6000 cps