Note: Ingredients listed on restricted chemical lists
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
N/A
General Information
Revision date
2018-07-04
Product name
Laminated cover board
1.2.1 Relevant identified uses
Roll roofing
Icons in SDS
Company Information
company name
IKO Industries Ltd
GHS Information
Signal word
Warning
Hazard Codes
Hazard statements (CLP)
H335, H336, H351
Hazard statements
Code
Statements
H335
May cause respiratory irritation
Section 2
2.1 Classification of the substance or mixture
The products listed above are considered end-use or manufactured articles, and are not included in the scope of WHMIS 2015 or Globally Harmonization System (GHS). As such, the GHS/WHMIS labeling elements and classification are not included on this SDS. Not applicable.
Signal word
Not applicable.
Hazard pictograms
Not applicable.
Hazard statements
H335 May cause respiratory irritation H336 May cause drowsiness or dizziness H351 Suspected of causing cancer
Precautionary statements
P201 Obtain special instructions before use. P202 Do not handle until all safety precautions have been read and understood. P280 Wear protective gloves, protective clothing, and eye protection. P308+P313 If exposed or concerned: Get medical advice/attention. P501 Dispose of contents/container in accordance with local, regional, national, provincial, territorial, and international regulations. NFPA SECTION 3 – CHEMICAL COMPOSITION AND DATA ON COMPONENTS HAZARDOUS CHEMICAL % (w/w) CAS NUMBER NAME MODIFIED BITUMEN BASE SHEET : Oxidized Asphalt (Bitumen) * 35-70 64742-93-4 Calcium Carbonate ** 15-35 1317-65-3 Sand ** 7-15 n/a Polyester Mat 5-10 n/a Styrene Rubber 3-7 n/a Polyethylene Film 0-1 9002-88-4 POLYISOCYANURATE INSULATION : Polyisocyanurate Foam 10-90 None. Pentane 2-10 109-66-0 Fiberglass 0-1 65997-17-3 * Note: During heat welding or hot mopping of product (if applicable), small amounts of toxic hydrogen sulfide H2S (CAS 7783-06-4) may be generated. ** Note: A small portion of crystalline silica (CAS # 14808-60-7) can be present in the sand and calcium carbonate used, but it is very unlikely that the concentration will be above the exposure limit.
