Note: Ingredients listed on restricted chemical lists
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
N/A
General Information
Revision date
2015-02-11
Product name
HTG CONCRETE SEAL PART A
Manufacturer Name
HILLYARD INDUSTRIES
Icons in SDS
Company Information
company name
HILLYARD INDUSTRIES
e-mail address of the competent person responsible for the Safety Data Sheet
regulatoryaffairs@hillyard.com
GHS Information
Signal word
Warning
Section 2
Physical hazards
Not classified.
Health hazards
Sensitization, skin Category 1
Environmental hazards
Not classified. OSHA defined hazards Not classified.
Signal word
Warning
Hazard statements
May cause an allergic skin reaction.
Prevention
Wear protective gloves. Contaminated work clothing should not be allowed out of the workplace. Use With Adequate Ventilation. Avoid breathing vapors or spray mist. Open windows and doors, use exhaust fans or other means to insure fresh air entry during application and drying.
Response
If on skin Wash with plenty of water. If skin irritation or rash occurs Get medical advice/attention IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Wash contaminated clothing before reuse.
Storage
Store away from incompatible materials.
Disposal
Buyer assumes all risk and liability associated with disposal of this product (original concentration or dilution) in violation of applicable law in compliance with applicable federal, state and local requirements. Hazard(s) not otherwise None known.
Additional information
None.
