Note: Ingredients listed on restricted chemical lists
EC/CAS
872-50-4
Name of the chemical
N-Methyl-2-Pyrrolidone; 1-methyl-2-pyrrolidone (NMP)
Concentration
N/A
General Information
Revision date
2018-06-15
Product name
BASECOAT II
1.2.1 Relevant identified uses
Gym Finish
Manufacturer Name
HILLYARD INDUSTRIES
Emergency telephone
(800) 424-9300
Icons in SDS
Company Information
company name
HILLYARD INDUSTRIES
e-mail address of the competent person responsible for the Safety Data Sheet
regulatoryaffairs@hillyard.com
GHS Information
Signal word
Danger
Section 2
Physical hazards
Not classified.
Health hazards
Acute toxicity, inhalation Category 5 Serious eye damage/eye irritation Category 2A Reproductive toxicity Category 1B
Environmental hazards
Not classified. OSHA defined hazards Not classified.
Signal word
Danger
Hazard statements
Causes serious eye irritation. May be harmful if inhaled. May damage fertility or the unborn child.
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Wash thoroughly after handling. Wear protective gloves/protective clothing/eye protection/face protection.
Response
IF INHALED Call a POISON CENTER or doctor/physician if you feel unwell. If in eyes Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If exposed or concerned: Get medical advice/attention. If eye irritation persists: Get medical advice/attention. Take off contaminated clothing and wash before reuse.
Storage
Store locked up.
Disposal
Buyer assumes all risk and liability associated with disposal of this product (original concentration or dilution) in violation of applicable law in compliance with applicable federal, state and local requirements. CONTAINER DISPOSAL: Triple rinse (or equivalent), then offer clean, dry container for recycling or reconditioning. Hazard(s) not otherwise None known.
Additional information
NOTICE: Saw dust from freshly sanded floors or dust from wood floors that have been abraded between coats will spontaneously catch fire if improperly discarded. Immediately after abrading or sanding wood floors, place dust waste in a sealed, water-filled metal container and immediately remove from building. NOTICE: Rags or applicators soaked in a combustible liquid will spontaneously catch fire if improperly discarded. Immediately after using rags or applicators soaked in a combustible liquid, place waste in a sealed, water-filled metal container and immediately remove from building.