Note: Ingredients listed on restricted chemical lists
EC/CAS
100-51-6
Name of the chemical
Benzyl Alcohol
Concentration
N/A
EC/CAS
122-99-6
Name of the chemical
2-Phenoxyethanol
Concentration
N/A
General Information
Revision date
2015-02-21
Product name
BASEBOARD STRIPPER GEL
1.2.1 Relevant identified uses
Stripper
1.2.2. Uses advised against
Do Not Use on Wood
Manufacturer Name
HILLYARD INDUSTRIES
Emergency telephone
(800) 424-9300
Icons in SDS
Company Information
company name
HILLYARD INDUSTRIES
e-mail address of the competent person responsible for the Safety Data Sheet
regulatoryaffairs@hillyard.com
GHS Information
Signal word
Danger
Section 2
Physical hazards
Not classified.
Health hazards
Acute toxicity, oral Category 5 Skin corrosion/irritation Category 1 Serious eye damage/eye irritation Category 1
Environmental hazards
Not classified. OSHA defined hazards Not classified.
Signal word
Danger
Hazard statements
May be harmful if swallowed. Causes severe skin burns and eye damage. Causes serious eye damage.
Prevention
Do not breathe mist or vapor. Wash thoroughly after handling. Wear protective gloves/protective clothing/eye protection/face protection.
Response
If swallowed: Rinse mouth. Do NOT induce vomiting. Immediately call a poison center/doctor. If on skin (or hair): Take off immediately all contaminated clothing. Rinse skin with water/shower. If inhaled Remove person to fresh air and keep comfortable for breathing. If in eyes Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a poison center/doctor. Wash contaminated clothing before reuse.
Storage
Store locked up.
Disposal
Buyer assumes all risk and liability associated with disposal of this product (original concentration or dilution) in violation of applicable law in compliance with applicable federal, state and local requirements. Hazard(s) not otherwise None known.
Additional information
Use With Adequate Ventilation. Avoid breathing vapors or spray mist. Open windows and doors, use exhaust fans or other means to insure fresh air entry during application and drying. Do not get in eyes, on skin, or on clothing. Keep container closed when not in use.
