Parts Washing Solvent

Hazard statements (CLP)

H226, H304, H336, H411

Code

Statements

H226

Flammable liquid and vapour

Hazardous Ingredients

DANGEROUS GOODS

Hazard classification according to the criteria of NOHSC

GHS Dangerous goods classification according to the Australian Dangerous Goods (ADG) Code, IATA and IMDG/IMSBC criteria. POISON SCHEDULE: S5

ADG classification

Class 3: Flammable liquids

UN Number

1300, TURPENTINE SUBSTITUTE 2. HAZARDS IDENTIFICATION (CONT)

Signal word

DANGER

Hazard statements

H226: Flammable liquid and vapour. AUH066: Repeated exposure may cause skin dryness or cracking. H304: May be fatal if swallowed and enters airways. H336: May cause drowsiness or dizziness. H411: Toxic to aquatic life with long lasting effects.

Prevention

P102: Keep out of reach of children. P210: Keep away from heat, sparks, open flames and hot surfaces. - No smoking. P233: Keep container tightly closed. P261: Avoid breathing fumes, mists, vapours or spray. P262: Do not get in eyes, on skin, or on clothing. P271: Use only outdoors or in a well ventilated area. P273: Avoid release to the environment. P280: Wear protective gloves, protective clothing and eye or face protection.

Response

P337 If eye irritation persists seek medical attention P301+P310 IF SWALLOWED Immediately call the POISONS INFORMATION CENTER on 13 11 26 or doctor. P301+P330+P331 IF SWALLOWED Rinse mouth. Do NOT induce vomiting P303+P361+P353 IF ON SKIN (or hair) Remove immediately all contaminated clothing Rinse skin with water. P304+P340 IF INHALED Remove victim to fresh air and keep at rest in a position comfortable for breathing. P370+P378: In case of fire, note the following. Normal foam, i.e. protein based foam that is not alcohol resistant, is the preferred medium for large fires. Try to contain spills, minimise spillage entering drains or water courses.

Storage

P402+P404: Store in a dry place. Store in a closed container. P403+P235: Store in a well-ventilated place. Keep cool.

Disposal

P501: If no in-house recycle or reclaim resources are suitable for this product, contact a specialist waste disposal company (see Section 13 of this SDS). 3. IDENTIFICATION / COMPOSITION OF INGREDIENTS Ingredients CAS No Conc, % TWA (mg/m3) STEL (mg/m3) Naphtha (petroleum), 64742-82-1 pure* not set hydrdesulfurized heavy *Commercially pure. Includes 1,2,4-trimethyl benzene and Xylene isomers each at <10%. This is a commercial product whose exact ratio of components may vary slightly. Minor quantities of other non hazardous ingredients are also possible. The TWA exposure value is the average airborne concentration of a particular substance when calculated over a normal 8 hour working day for a 5 day working week. The STEL (Short Term Exposure Limit) is an exposure value that should not be exceeded for more than 15 minutes and should not be repeated for more than 4 times per day. There should be at least 60 minutes between successive exposures at the STEL. The term "peak "is used when the TWA limit, because of the rapid action of the substance, should never be exceeded, even briefly.