Note: Ingredients listed on restricted chemical lists
EC/CAS
108-88-3
Name of the chemical
Toluene
Concentration
1%-5%
EC/CAS
7631-86-9
Name of the chemical
Silver adsorbed on silicon dioxide
Concentration
1%-5%
EC/CAS
25068-38-6
Name of the chemical
4,4'-Isopropylidenediphenol, oligomeric reaction products with 1-chloro-2,3-epoxypropane
Concentration
10%-20%
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
5%-10%
EC/CAS
111-76-2
Name of the chemical
Ethylene glycol monobutyl ether (EGBE)
Concentration
1%-5%
EC/CAS
14807-96-6
Name of the chemical
Talc
Concentration
5%-10%
EC/CAS
7789-06-2
Name of the chemical
Strontium chromate
Concentration
5%-10%
EC/CAS
108-10-1
Name of the chemical
4-methylpentan-2-one; isobutyl methyl ketone (MIBK)
Concentration
1%-5%
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
5%-10%
General Information
Revision date
2019-05-09
Product name
FLUID RESISTANT EPOXY PRIMER BAC-452
1.2.1 Relevant identified uses
Industrial paint (Paint or Paint-Related), Restricted to
Icons in SDS
Company Information
company name
Hentzen Coatings, Inc
GHS Information
Signal word
DANGER
Section 2
2.1 Classification of the substance or mixture
OSHA Regulatory Status This chemical is considered hazardous by the 2012 OSHA Hazard Communication Standard (29 CFR 1910.1200) Acute toxicity - Inhalation (Dusts/Mists) Category 4 Skin Corrosion/Irritation Category 2 Serious eye damage/eye irritation Category 2 Skin sensitization Category 1 Carcinogenicity Category 1A Reproductive Toxicity Category 2 Specific target organ toxicity (repeated exposure) Category 2 Flammable Liquids Category 2
2.2 Label elements
Emergency Overview DANGER
Hazard statements
harmful if inhaled Causes skin irritation Causes serious eye irritation May cause an allergic skin reaction May cause cancer Suspected of damaging fertility or the unborn child May cause damage to organs through prolonged or repeated exposure Highly flammable liquid and vapor Appearance Opaque Physical state Liquid Odor Solvent
Prevention
Obtain special instructions before use Do not handle until all safety precautions have been read and understood Use personal protective equipment as required Use only outdoors or in a well-ventilated area Wash face, hands and any exposed skin thoroughly after handling Contaminated work clothing should not be allowed out of the workplace Do not breathe dust/fume/gas/mist/vapors/spray Keep away from heat/sparks/open flames/hot surfaces. - No smoking Keep container tightly closed Ground/Bond container and receiving equipment Use explosion-proof electrical/ ventilating/ lighting/ equipment Use only non-sparking tools Take precautionary measures against static discharge Wear protective gloves/protective clothing/eye protection/face protection
Response
IF exposed or concerned: Get medical advice/attention IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing If eye irritation persists: Get medical advice/attention If skin irritation or rash occurs: Get medical advice/attention IF ON SKIN (or hair): Remove/Take off immediately all contaminated clothing. Rinse skin with water/shower Wash contaminated clothing before reuse IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing In case of fire: Use CO2, dry chemical, or foam for extinction
Storage
Store in a well-ventilated place. Keep cool Store in accordance with local regulations
Precautionary statements
Disposal Dispose of contents/container to an approved waste disposal plant
Further information
May be harmful if swallowed • May be harmful in contact with skin • Toxic to aquatic life
