General Information
Version
003.1
Revision date
2016-01-11
Product name
Loctite(R} Nickel Grade Anti-Seize
Emergency telephone
1-877-671-4608, 1-303-592-1711, 1-800-424-9300, 1-703-527-3887
Icons in SDS
Company Information
company name
Henkel Corporation
GHS Information
Signal word
DANGER
Hazard Codes
Hazard statements (CLP)
H315, H317, H319
Hazard statements
Code
Statements
H315
Causes skin irritation
Section 2
SECTION 2: Hazards identification
OSHA EMERGENCY OVERVIEW DANGER: CONTENTS UNDER PRESSURE. EXTREMELY FLAMMABLE AEROSOL. MAY BE FATAL IF SWALLOWED AND ENTERS AIRWAYS. CAUSES SKIN IRRITATION. MAY CAUSE AN ALLERGIC SKIN REACTION. CAUSES SERIOUS EYE IRRITATION. MAY CAUSE DROWSINESS OR DIZZINESS. SUSPECTED OF CAUSING CAN
Hazard categories
FLAMMABLE AEROSOL SKIN IRRITATION EYE IRRITATION 2A SKIN SENSITIZATION CARCINOGENICITY SPECIFIC TARGET ORGAN TOXICITY SINGLE EXPOSURE
Aspiration hazard
PICTOGRAM(S)
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Keep away from heat, sparks, open flames, hot surfaces - no smoking. Do not spray on an open flame or other ignition source. Do not pierce or burn, even after use. Avoid breathing mist or spray. Wash affected area thoroughly after handling. Use only outdoors or in a well-ventilated area. Contaminated work clothing should not be allowed out of the workplace. Wear protective gloves, clothing. eye and face protection. IDH number: 234296 Product name: Loctite(R) Nickel Grade Anti-Seize Page 1 of 7 Unusual fire or explosion hazards: Contents under pressure. Do not puncture or incinerate pressurized containers. Do not handle or store near an open flame, heat or other sources of ignition. Exposure fo femperatures above 49°C (120°F) may cause container to burst. Hazardous combustion products: Oxides of carbon. 6. ACCIDENTAL RELEASE MEASURES Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected personnel. Environmental precautions: Do not allow product to enter sewer or waterways. Clean-up methods: Ensure adequate ventilation. Remove all sources of ignition. Soak up with inert absorbent material (e.g. sand, silica gel, acid binder, universal binder, sawdust). Remove the absorbed material, and place in an appropriate chemical waste container for disposal. 7. HANDLING AND STORAGE Handling: Prevent contact with eyes, skin and clothing. Do not breathe vapor and mist. Wash thoroughly after handling. Keep away from heal, spark and flame. Vapors will accumulate readily and may ignite explosively. Refer to Section 8.
Storage
Keep in a cool, well ventilated area away from heat, sparks and open flame. Keep container tightly closed until ready for use, Do not puncture, incinerate, or expose to temperatures above 48.9 °C (120 °F). 8. EXPOSURE CONTROLS / PERSONAL PROTECTION Employers should complete an assessment of all workplaces to determine the need for, and selection of, proper exposure controls and protective equipment for each task performed. irdous Component(s) ACGIH TLV
2.1 Classification of the substance or mixture
HAZARD CATEGORY FLAMMABLE AEROSOL. 1 SKIN IRRITATION 2 EYE IRRITATION 2A SKIN SENSITIZATION i CARCINOGENICITY 2 “SPECIFIC TARGET ORGAN TOXICITY - SINGLE EXPOSURE 3 ASPIRATION HAZARD i PICTOGRAM(S)