Polytetrafluoroethylene

Health hazards

Data Threshold Limit Value: 5 mg/m3 for oil mist in air. Effects of Overexposure: First Aid Procedures: Skin: May Cause Irritation Skin: Remove contaminated clothing from irritated area. Flush Eyes: Eye Irritant. May cause redness and Blurred vision. exposed area with mild soap and water. Seek medical attention if Ingestion: Not Expected irritation persists. Inhalation: Not Expected (Chronic respiratory diseases may be Eyes: Flush eyes with large quantities of water, holding eyelids open. aggravated by dust exposure.) Seek medical attention if irritation persists. NFPA CODES: Health: 1 Ingestion: Do not induce vomiting. If spontaneous vomiting occurs, Flammability: 1 keep head below hips to avoid aspiration into the lungs. Seek Reactivity: 0 immediate medical attention. Carcinogenicity: Silica is a suspected carcinogen in a respirable Inhalation: Remove to fresh air. Obtain medical attention if form by the IARC and NTP however not by the ACIGH or

Appearance/Odor

Smooth, white grease with mineral oil odor. Section 7 - Reactivity Data Stability: Unstable Conditions to Avoid: N/A Stable X Incompatibility (Materials to Avoid): Avoid contact with strong oxidants like liquid chlorine, concentrated oxygen. Hazardous Decomposition or Byproducts: May form SO If incomplete combustion, Carbon Monoxide. 2. Hazardous Polymerization: May Occur Conditions to Avoid: N/A Will Not Occur X Section 8 - Spill or Leak Procedures Steps to be taken in case material is released or spilled: Scrape up grease, wash remainder with suitable petroleum solvent or add absorbent. Keep petroleum products out of sewers and watercourses. Advise authorities if product has entered or may enter sewers and watercourses. Waste disposal method: Assure conformity with applicable disposal regulations. Dispose of absorbed material at an approved waste disposal facility or site. SARA/TITLE III, Section 313 Status - Zinc Compounds - <6% Section 9 - Special Protection Information Respiratory Protection (Specify type): Normally not needed Ventilation Local Exhaust: Used to capture fumes and vapors Special: N/A Mechanical (General) Other: N/A Protective Gloves: Use oil-resistant gloves, if needed. Eye Protection: If chance of eye contact, wear goggles. Other Protective Equipment: Use oil-resistant apron, if needed. Section 10 - Special Precautions Precautions to be taken in handling and storing: Keep containers closed when not in use. Do not handle or store near heat, sparks, flame, or strong oxidants. Other Precautions: Remove oil-soaked clothing and launder before reuse. Cleanse skin thoroughly after contact. The above information is furnished without warranty, expressed or implied, except that it is accurate to the best knowledge of Fiske Brothers Refining Company. The data on these sheets relates only to the specific material designated herein. Fiske Brothers Refining Company assumes no legal responsibility for use or reliance upon this data. Issue date January, 2006 Prepared by: James R. Kontak KMT 20416107 SECTION 1 – PRODUCT IDENTIFICATION Product Name: JL-M Lubricant Manufacturer’s Name: Superbolt, Inc. Revised: 03/07/03 Supercedes: 03/17/00 Manufacturer’s Address: 1000 Gregg Street Prepared by: C. Semerod Carnegie, PA 15106 Emergency Information: (412) 279-1149 Manufacturer’s Phone #: (412) 279-1149 Dark Grey Paste, Mild Petroleum Flash Point: 338 degrees F Boiling Point: > 500 degrees F Lower Explosive Limit: N/A % Volatile: 0% Upper Explosive Limit: N/A Vapor Density: > 1 (Air = 1) Extinguishing Media: Carbon Dioxide, Regular Foam, Dry Chemical Evaporation Rate: < 1 (Ether = 1) Special Fire Fighting Procedures: Fire may produce dense smoke, Specific Gravity: 4.8 (Water = 1) firefighters should wear self contained breathing apparatus. Use Vapor Pressure: Essentially 0 (mm Hg) water to cool fire exposed containers. Solubility in Water: Insoluble Unusual Fire & Explosion Hazards: Decomposition and combustion pH: N/A by-products may be toxic. Heated containers may rupture or explode. SECTION 5 – REACTIVITY DATA

Hazardous Ingredients

CHEMICAL NAME: CAS NO.

Storage

HANDLING Stability: Stable Hazardous Polymerization: Will not occur. Handling Precautions: Use good personal hygiene practices. Clean Incompatibility: Avoid contact with oxidizing agents, heat, sparks or contaminated clothing and protective equipment before reuse. flame. Hazardous Combustion By-Products: Carbon Monoxide, Sulfur Precautions Store in a cool dry location. Keep container Dioxide, Aldehydes, and Nitrogen Oxides tightly closed when not in use and during transport. Keep away from Hazardous Decomposition: Thermal decomposition may yield open sparks or flames. methacrylate monomers. For safe storage, store at or below 38 °C (100.4 °F) Keep in a cool, well ventilated area away from heat, sparks and open flame. Keep container tightly closed until ready for use. For information on product shelf life contact Henkel Customer Service at (800) 243-4874. 8. EXPOSURE CONTROLS / PERSONAL PROTECTION Employers should complete an assessment of all workplaces to determine the need for, and selection of, proper exposure controls and protective equipment for each task performed. IDH number: 230718 Product name: Loctite(R) 242(R) Threadlocker Medium Strength Page 2 of 6 KMT 72102733 Hazardous components ACGIH TLV

Disposal

Procedures Dispose of in accordance with any applicable approved respirator if levels exceed

SECTION 2: Hazards identification

EMERGENCY OVERVIEW HMIS: Physical state: Liquid HEALTH: *2 Color: Blue FLAMMABILITY: 1 Odor: Mild

Physical hazards

1 Personal Protection: See MSDS Section 8 WARNING: CAUSES EYE IRRITATION. MAY CAUSE SKIN IRRITATION. MAY CAUSE ALLERGIC SKIN REACTION. MAY CAUSE RESPIRATORY TRACT IRRITATION.

Principle Routes of Exposure

Skin, Inhalation, Eyes

Potential health effects

Inhalation: May cause respiratory tract irritation. Skin contact: May cause allergic skin reaction. May cause skin irritation. Eye contact: Contact with eyes will cause irritation. Ingestion: Not expected to be harmful by ingestion. Existing conditions aggravated by Eye, skin, and respiratory disorders. exposure: This material is considered hazardous by the

TOXICOLOGICAL INFORMATION

Acute oral product toxicity: LD50 (rat) > 10,000 mg/kg Acute dermal product toxicity: LD50 (rabbit) > 5,000 mg/kg

ECOLOGICAL INFORMATION

Not available. IDH number: 230718 Product name: Loctite(R) 242(R) Threadlocker Medium Strength Page 4 of 6 KMT 72102733 13. DISPOSAL CONSIDERATIONS Information provided is for unused product only. Recommended method of disposal: Follow all local, state, federal and provincial regulations for disposal. Hazardous waste number: Not a RCRA hazardous waste. 14. TRANSPORT INFORMATION The shipping classifications in this sections are for non-bulk packaging only (unless otherwise specified). Shipping classification may be different for bulk packaging. U.S. Department of Transportation Ground (49 CFR) Proper shipping name: Not regulated Hazard class or division: None Identification number: None Packing group: None International Air Transportation (ICAO/IATA) Proper shipping name: Not regulated Hazard class or division: None Identification number: None Packing group: None Water Transportation (IMO/IMDG) Proper shipping name: Not regulated Hazard class or division: None Identification number: None Packing group: None 15. REGULATORY INFORMATION United States Regulatory Information TSCA 8 (b) Inventory Status: All components are listed or are exempt from listing on the Toxic Substances Control Act Inventory. TSCA 12(b) Export Notification: None above reporting de minimus CERCLA/SARA Section 302 EHS: None above reporting de minimus CERCLA/SARA Section 311/312: Immediate Health, Delayed Health CERCLA/SARA 313: This product contains the following toxic chemicals subject to the reporting requirements of section 313 of the Emergency Planning and Community Right-To-Know Act of 1986 (40 CFR 372). Cumene hydroperoxide (CAS# 80-15-9).

Further information

This material safety data sheet contains changes from the previous version in sections: 3, 8, 11 Prepared by: Kyra Kozak Woods, Manager, Regulatory Affairs IDH number: 230718 Product name: Loctite(R) 242(R) Threadlocker Medium Strength Page 5 of 6 KMT 72102733 DISCLAIMER: The data contained herein are furnished for information only and are believed to be reliable. However, Henkel Corporation and its affiliates (“Henkel”) does not assume responsibility for any results obtained by persons over whose methods Henkel has no control. It is the user’s responsibility to determine the suitability of Henkel’s products or any production methods mentioned herein for a particular purpose, and to adopt such precautions as may be advisable for the protection of property and persons against any hazards that may be involved in the handling and use of any Henkel’s products. In light of the foregoing, Henkel specifically disclaims all warranties, express or implied, including warranties of merchantability and fitness for a particular purpose, arising from sale or use of Henkel’s products. Henkel further disclaims any liability for consequential or incidental damages of any kind, including lost profits. IDH number: 230718 Product name: Loctite(R) 242(R) Threadlocker Medium Strength Page 6 of 6