EA 9330Part A Bulk

Physical hazards

OSHA 1 Personal Protection: See Section 8 DANGER: CAUSES EYE AND SKIN BURNS, ; CAUSES RESPIRATORY TRACT IRRITATION. MAY CAUSE ALLERGIC SKIN REACTION.

Principle Routes of Exposure

Skin, Inhalation, Eyes

Potential health effects

inhalation: Respiratory tract bums. a Skin contact: May cause skin bums. Repeated or prolonged skin contact may result in allergic sensitization. Eye contact: Severe eye Irritation, Possible burns to eyes. Ingestion: Not expected under normal conditions of use. May be harmful if swallowed. Aspiration may occur during swallowing or vomiting, resulting in lung damage. Existing conditions aggravated by Eye, skin, and respiratory disorders. exposure: See Section 11 for additional toxicological information. Item No. AB9363000 Product name: EA°9330 ‘Part B Bulk 10f5 “ Inhalation: Remove to fresh air. If discomfort persists seek medical attention. Skin contact: Immediately flush skin with plenty of water (using soap, if available). Remove contaminated clothing and shoes. Get medical attention if symptoms occur. . Eye contact: Immediately flush eyes with plenty of water for at least 15 minutes, Get medical attention. Ingestion: Drink water as a precaution. Get medical attention immediately. Notes to physician: Treat symptomatically and supportively. This.material is an aspiration hazard. Potential danger from aspiration must be weighed against possible oral toxicity when deciding whether to induce vomiting. Flash point: Greater than 93°C (200°F) (estimated) Autoignition temperature: * Not determined Flammable/Explosive limits-lower %: Not determined Flammable/Explosive limits-upper %: Not determined Extinguishing media: Water spray (fog), foam, dry chemical or carbon dioxide. Special fire fighting procedures: Wear self-contained breathing apparatus and full protective clothing, such as turn-out gear. Cartridge respirators do not provide adequate protection for fire fighters or exotherm mitigation. Unusual fire or explosion hazards: May liberate large qua’ gasses; ~ - ss---+ Hazardous combustion products: Oxides of carbon and nitrogen, aldehydes, acids and undetermined organics. Environmental precautions: Prevent further leakage or spillage if safe to do so. Do not contaminate water. Clean-up methods: Wear protective clothing, gloves and safety glasses. Soak up with inert absorbent, Store in a closed contalner until ready for disposal. Handling: For the Part A plus Part B adhesive mixture, follow curing schedule as recommended in product literature. Do not heat Part B at temperatures greater than 100 °C (212 °F). This material may self- react at higher temperatures and cause an exotherm. The exotherm has the potential for release of excessive energy and toxic gasses. Empty containers retain product residue, so obey hazard warnings and handle empty containers as if they were full. Do not cut, grind, weld, or drill on or near this container.

Storage

For safe storage, store at or below 25°C (77°F). Keep container closed, Incompatible products: Keep away from strong oxidizing agents, strong Lewis or mineral acids. For information on product shelf life, please review labels on container or check the Technical Data Sheet. Engineering controls: Use local ventilation if general ventilation is insufficient to maintain vapor concentration below established exposure limits. Item No. A8B9363000 Product name: EA 9330 Part B Bulk 2 of 5 . a Respiratory protection: When workplace hazards warrant the use of a respirator, appropriate respirators must be used. Use a NIOSH approved air-purifying respirator if the potential to exceed established exposure limits exists.