PL(R)

SECTION 2: Hazards identification

CHRONIC HAZARDS: Preexisting respiratory or skin conditions may be aggravated by exposure. This product contains an isocyanate. Skin and respiratory sensitization can result from repeated exposures to isocyanates. For most individuals these effects are reversible. Persons previously sensitized to isocyanates may experience an allergic respiratory reaction: signs/symptoms can include difficulty breathing, wheezing, tightness of chest, and respiratory failure. SILICA:Normal use of this product does not produce dust. Sanding dried material could generate trace amounts of Silica (quartz ) which is a suspect human carcinogen (IARC group 1 ). Repeated and prolonged occupational overexposure to Crystalline Silica may cause silicosis, a progressively disabling lung disease. NOTICE: Reports have associated repeated and prolonged occupational overexposure to solvents with permanent brain, nervous system, liver or kidney damage or may cause cardiac - arrhythmia. INTENTIONAL misuse of this product by deliberately inhaling its vapors may be harmful or fatal. SECTION VI - STABILITY AND REACTIVITY Stability: This product is stable Hazardous Polymerization: Hazardous polymerization will not occur INCOMPATABILITY: Keep away from strong oxidizing agents, alkalies, acids, and water contamination. CONDITIONS TO AVOID: Keep away from heat, spark, and open flame. Product cures in contact with water. HAZARDOUS DECOMPOSITION PRODUCTS: Will produce fumes and smoke containing carbon monoxide and dioxide and nitrogen oxides under fire conditions. SAFETY DATA SHEET MSDS Name: PL(R) MSDS Number: P77913125 Version Number 2 Revision Date: OCT-13-2005 Page Number: 1 t 1 ' I 1 T i] 1 SUCTION VII - ACCIDENTAL RELEASE AND DISPOSAL MEASURES: STEPS TO BE TAKEN IN CASE OF SPILL: Eliminate all ignition sources. Ventilate confined areas. (Open windows and doors) Cover with absorbent, scoop into sealable safety container. Wear protective clothing. WASTE DISPOSAL METHOD: Dispose of following local, state, and federal regulations. SECTION VIII - EXPOSURE CONTROLS/PERSONAL PROTECTION Occupational Exposure Limits ACGIH OSHA TLV PEL ACGTH TLV-C ACGIH STEL OSHA STEL Titanium Dioxide ** 10.00 mg/F3 N/est 15.00 mg/F3 STODDARD SOLVENT 100.00 PPM N/est 100.00 PPM SILICA, QUARTZ 0.05 mg/F3 N/est 0.10 mg/M3 2,4 Toluene Diisocyanate 0.01 PPM N/est 0.02 PPM 0.01 Note: The TLV for Silica is for the respirable fraction of dust only. RESPIRATORY PROTECTION: If TLV of the product is exceeded, wear NIOSH/MSHA jointly approved respiratory protection in the absence ef proper ventilation. Follow applicable OSHA regulations. VENTILATION: Provide sufficient mechanical (general and/or local exhaust) ventilation to maintain exposure below TLV. Ventilate during application and curing of this product. PROTECTIVE CLOTHING: Rubber gloves should be worn. Cover arms and legs to minimize exposure.