PL-300

Health hazards

DATA

Principle Routes of Exposure

ENTRY THROUGH Inhalation? YES | Skin? YES {| Ingestion? YES

Contains

N-Hexane (110-54-3) in trace quantities, which can cause. peripheral neuropathy & nervous system damage. CARCINOGENICITY... NTP? N/E | IARC Monographs? N/E | OHSA? NO EFFECTS OF OVEREXPOSURE Eyes: Can cause irritation, redness, tearing and blurred vision. Skin: Prolonged or repeated contact can cause moderate irritation, defatting, and dermatitis. Inhalation: May cause nose or throat irritation. High concen- trations may cause acute central nervous system depression characterized by headaches, dizziness, nausea and confusion. Ingestion: Can cause gastrointestinal irritation, nausea, vomiting and diarrhea. FIRST AID MEASURES Eyes: Flush eyes gently with water for at least 15 minutes 3 lifting eyelids occasionally; get prompt medical attention Skin: Wash thoroughly with soap and water; apply a mild skin cream. Remove contaminated clothing. Inhalation: Move affected person to fresh air; if breathing is difficult, administer oxygen; if breathing has stopped, give artificial respiration. Get medical attention. Ingestion: DO NOT INDUCE VOMITING! Get immediate medical attention. CHRONIC

SECTION 2: Hazards identification

NOTICE: Reports have associated repeated and prolonged occupational overexposure to solvents with permanent brain, nervous system, liver or kidney damage or may cause cardiac arrhythmia. INTENTIONAL misuse of this product by deliberately inhaling its vapors may be harmful or fatal. SILICA:Normal use of this product does not produce dust. Sanding dried material could generate trace amounts of Silica (quartz ) which is a suspect human carcinogen (IARC group 1 ). Repeated and prolonged occupational overexposure to Crystalline Silica may cause silicosis, a progressively disabling lung disease. SECTION VI - STABILITY AND REACTIVITY Stability: This product is stable Hazardous Polymerization: Hazardous polymerization will not occur INCOMPATABILITY: Keep away from strong oxidizing agents. CONDITIONS TO AVOID: Keep away from heat, spark, open flames and any ignition source. HAZARDOUS DECOMPOSITION PRODUCTS: Will produce fumes and smoke containing carbon monoxide and dioxide under fire conditions. SECTION VII - ACCIDENTAL RELEASE AND DISPOSAL MEASURES: STEPS TO BE TAKEN IN CASE OF SPILL: Eliminate all ignition sources. Ventilate confined areas. (Open windows and doors). Wear appropriate protective clothing. “syver with absorbent. Scoop into sealable safety container. WASTE DISPOSAL METHOD: Dispose of following local, state, and federal regulations. SECTION VIII - EXPOSURE CONTROLS/PERSONAL PROTECTION Occupational Exposure Limits ACGIH OSHA PEL TLV ACGIH TLV-C ACGIH STEL OSHA STEL Light Hydrotreated Naphtha 400.00 PPM N/est 400.00 PPM SILICA, QUARTZ 0.05 mg/F3 N/est 0.10 mg/M3 Note: The TLV for Silica is for the respirable fraction of dust only. RESPIRATORY PROTECTION: Tf TLV of the product is exceeded, a NIOSH/MSHA jointly approved air supply respirator is advised in the absence of proper ventilation. OSHA regulations also permit the use of other types of NIOSH/MSHA respirators under specified conditions. (See your safety equipment supplier for more information) VENTILATION: Provide sufficient mechanical