LOCTITE SF 790 GASKET REMOVER know n as LOCTITE Chisel Paint Strippe

Henkel Canada Corporation

Revision date : 2017-07-19

SDS Library

Move your SDS library online today

Check Icon
Setup – Easy setup with our database of 16 million+ SDSs
Check Icon
Up-to-date – Your SDS get updated to latest versions.
Check Icon
Employee access – Tablets, Smartphones, or link from Corporate Intranet
Check Icon
Safety – One-click access to first aid information.
Check Icon
Labels – Generate Secondary Container Labels with just one click.
Health risk rating 1
Safety risk rating 1
Environmental risk rating 1

Note: Ingredients listed on restricted chemical lists

EC/CAS

68476-86-8

Name of the chemical

Petroleum gases, liquefied, sweetened; Petroleum gas (A complex combination of hydrocarbons obtained by subjecting liquefied petroleum gas mix to a sweetening process to convert mercaptans or to remove acidic impurities. It consists of hydrocarbons having carbon numbers predominantly in the range of C3 through C7 and boiling in the range of approximately - 40 °C to 80 °C.)

Concentration

N/A

General Information

Revision date

2017-07-19

Product name

LOCTITE SF 790 GASKET REMOVER know n as LOCTITE Chisel Paint Strippe

Icons in SDS

Company Information

company name

Henkel Canada Corporation

GHS Information

Signal word

DANGER

Section 2

SECTION 2: Hazards identification

WHMIS 2015 EMERGENCY OVERVIEW DANGER: CONTENTS UNDER PRESSURE. EXTREMELY FLAMMABLE AEROSOL. MAY BE FATAL IF SWALLOWED AND ENTERS AIRWAYS. CAUSES SKIN IRRITATION. CAUSES SERIOUS EYE IRRITATION. MAY CAUSE DROWSINESS OR DIZZINESS. SUSPECTED OF CAUSING CANCER. CAUSES DAMAGE TO ORGANS. MAY CAUSE DAMAGE TO ORGANS THROUGH PROLONGED OR REPEATED EXPOSURE.

Hazard categories

FLAMMABLE AEROSOL. 1 SKIN IRRITATION 2 EYE IRRITATION 2A CARCINOGENICITY 2 SPECIFIC TARGET ORGAN TOXICITY - SINGLE EXPOSURE 1 SPECIFIC TARGET ORGAN TOXICITY - SINGLE EXPOSURE 3 SPECIFIC TARGET ORGAN TOXICITY - REPEATED EXPOSURE 2

Aspiration hazard

1

Prevention

Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Keep aw ay from heat, sparks, open flames, hot surfaces - no smoking. Do not spray on an open flame or other ignition source. Do not pierce or burn, even after use. Do not breathe mist or spray. Wash affected area thoroughly after handling. Do not eat, drink or smoke w hen using this product. Use only outdoors or in a w ell-ventilated area. Wear protective gloves, clothing, eye and face protection.

Response

IF SWALLOWED Immediately call a physician or poison control center. IF ON SKIN Wash w ith plenty of w ater. IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing. Call a POISON CENTER or physician if you feel unw ell. IF IN EYES: Rinse cautiously w ith water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If exposed: Call a poison center or physician. Do NOT induce vomiting. If skin irritation occurs Get medical attention. If eye irritation persists Get medical attention. Take off contaminated clothing.

Storage

Store in a w ell-ventilated place. Keep container tightly closed. Store locked up. Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F.

Disposal

Dispose of contents and/or container according to Federal, State/Provincial and local governmental regulations. 2 % of the mixture consists of ingredient(s) of unknow n acute toxicity. Classification complies w ith Canadian Hazardous Products Regulations (WHMIS 2015) and is consistent w ith the provision of the United Nations Globally Harmonized System of Classification and Labeling of Chemicals (GHS). See Section 11 for additional toxicological information.

SDS Library

Move your SDS library online today

Check Icon
Setup – Easy setup with our database of 16 million+ SDSs
Check Icon
Up-to-date – Your SDS get updated to latest versions.
Check Icon
Employee access – Tablets, Smartphones, or link from Corporate Intranet
Check Icon
Safety – One-click access to first aid information.
Check Icon
Labels – Generate Secondary Container Labels with just one click.