Note: Ingredients listed on restricted chemical lists
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
90-100 1-<3
General Information
Revision date
2015-02-26
Product name
CC E-Series Opta 60-1.9R
1.2.1 Relevant identified uses
Coated Sand for Foundry Molds and Cores
1.2.2. Uses advised against
Workers (and your customers or users in the case of resale) should be informed of the potential presence of respirable dust and respirable crystalline silica as well as their potential hazards Appropriate training in the proper use and handling of this material should be provided as required under applicable regulations
Manufacturer Name
HA International, LLC
Emergency telephone
1-866-303-6949, 800-424-9300, 703-527-3887
Icons in SDS
Company Information
company name
HA International, LLC
e-mail address of the competent person responsible for the Safety Data Sheet
msdsquestions@ha-international.com
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H302+H312, H350
Hazard statements
Code
Statements
H302+H312
Harmful if swallowed or in contact with skin
Section 2
SECTION 2: Hazards identification
Physical hazards
Not classified
Health hazards
Acute toxicity, oral Category 4 Acute toxicity, dermal Category 4 Carcinogenicity Category 1A
Environmental hazards
Not classified
Signal word
Danger
Hazard statements
Harmful if swallowed. Harmful in contact with skin. May cause cancer.
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Wash thoroughly after handling. Do not eat, drink or smoke when using this product. Wear protective gloves/protective clothing/eye protection/face protection. Take precautionary measures, such as capturing dust at generation points, practicing good housekeeping, controlling sources of ignition (including static electricity), and grounding equipment, to minimize dust accumulation, airborne dust, and static discharges during handling and/or conveyance. Prevent personnel exposure to dust, smoke, and fumes generated from pouring, cooling and shakeout operations through the use of effective local and general exhaust ventilation systems and/or personal protective equipment. Personnel exposure monitoring should be conducted periodically to verify these systems are operating in a manner that prevents employee exposures above applicable criteria.
Response
If swallowed Call a poison center/doctor if you feel unwell. If on skin Wash with plenty of water. If exposed or concerned: Get medical advice/attention. Call a poison center/doctor if you feel unwell. Specific treatment (see this label). Rinse mouth. Take off contaminated clothing and wash before reuse.
Storage
Store locked up.
Disposal
Dispose of contents/container in accordance with local/regional/national/international regulations. Hazard(s) not otherwise Hazardous emissions are normally generated when cores or molds are exposed to molten metal classified (HNOC) during pouring, cooling and shakeout operations. Formaldehyde may be released from this product during processing. THIS PRODUCT IS COATED WITH A PHENOLIC RESIN WHICH MAY ABRADE DURING HANDLING OR MECHANICAL CONVEYANCE GENERATING ORGANIC DUST. WHEN HANDLING OR CONVEYING IN ENCLOSED SPACES, ANY ABRADED PHENOLIC RESIN DUST FROM THIS PRODUCT CAN BE COMBUSTIBLE AND MAY PRESENT A FIRE OR EXPLOSION HAZARD WHEN DISPERSED AND IGNITED IN AIR
Additional information
99.43% of the mixture consists of component(s) of unknown acute oral toxicity. 99.53% of the mixture consists of component(s) of unknown acute dermal toxicity.
2.1 Classification of the substance or mixture
Not classified. Health hazards Acute toxicity, oral Category 4 Acute toxicity, dermal Category 4 Carcinogenicity Category 1A Environmental hazards Not classified. OSHA defined hazards Not classified.
