Note: Ingredients listed on restricted chemical lists
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
96.19
EC/CAS
100-97-0
Name of the chemical
Hexamethylenetetramine
Concentration
<0.2
General Information
Revision date
2017-05-26
Product name
CC E-Series HAI 60-2.0
1.2.1 Relevant identified uses
Coated Sand for Foundry Molds and Cores
1.2.2. Uses advised against
Workers (and your customers or users in the case of resale) should be informed of the potential presence of respirable dust and respirable crystalline silica as well as their potential hazards Appropriate training in the proper use and handling of this material should be provided as required under applicable regulations
Manufacturer Name
HA International, LLC
Icons in SDS
Company Information
company name
HA International, LLC
e-mail address of the competent person responsible for the Safety Data Sheet
msdsquestions@ha-international.com
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H317, H334, H350, H372
Hazard statements
Code
Statements
H317
May cause an allergic skin reaction
Section 2
SECTION 2: Hazards identification
Physical hazards
Not classified
Health hazards
Sensitization, respiratory Category 1 Sensitization, skin Category 1 Carcinogenicity Category 1A Specific target organ toxicity, repeated Category 1 exposure
Environmental hazards
Not classified
Signal word
Danger
Hazard statements
May cause an allergic skin reaction. May cause allergy or asthma symptoms or breathing difficulties if inhaled. May cause cancer. Causes damage to organs through prolonged or repeated exposure.
Prevention
This is a hazardous chemical product. It is important that all employees working with this product receive initial and periodic refresher training in its safe use and handling, both for basic risk
Response
If on skin Wash with plenty of water. If inhaled If breathing is difficult, remove person to fresh air and keep comfortable for breathing. If exposed or concerned: Get medical advice/attention. If skin irritation or rash occurs Get medical advice/attention. If experiencing respiratory symptoms Call a poison center/doctor. Wash contaminated clothing before reuse.
Storage
Store locked up.
Disposal
Dispose of contents/container in accordance with local/regional/national/international regulations. Hazard(s) not otherwise Hazardous emissions are normally generated when cores or molds are exposed to molten metal classified (HNOC) during pouring, cooling and shakeout operations. Formaldehyde may be released from this product during processing. THIS PRODUCT IS COATED WITH A PHENOLIC RESIN WHICH MAY ABRADE DURING HANDLING OR MECHANICAL CONVEYANCE GENERATING ORGANIC DUST. WHEN HANDLING OR CONVEYING IN ENCLOSED SPACES, ANY ABRADED PHENOLIC RESIN DUST FROM THIS PRODUCT CAN BE COMBUSTIBLE AND MAY PRESENT A FIRE OR EXPLOSION HAZARD WHEN DISPERSED AND IGNITED IN AIR
Additional information
97.81% of the mixture consists of component(s) of unknown acute hazards to the aquatic environment. 97.81% of the mixture consists of component(s) of unknown long-term hazards to the aquatic environment.
2.1 Classification of the substance or mixture
Not classified. Health hazards Sensitization, respiratory Category 1 Sensitization, skin Category 1 Carcinogenicity Category 1A Specific target organ toxicity, repeated Category 1 exposure Environmental hazards Not classified. OSHA defined hazards Not classified.
