Note: Ingredients listed on restricted chemical lists
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
N/A
EC/CAS
107-21-1
Name of the chemical
Ethane-1,2-diol
Concentration
N/A
EC/CAS
64742-65-0
Name of the chemical
Distillates (petroleum), solvent-dewaxed heavy paraffinic
Concentration
N/A
EC/CAS
1333-86-4
Name of the chemical
carbon black
Concentration
N/A
EC/CAS
14464-46-1
Name of the chemical
Cristobalit (s. u. TRGS 906)
Concentration
N/A
General Information
Version
15
Revision date
2021-09-27
Product name
H&C COLORTOP Water-Based Solid Color Concrete Stain Silver Gray
Manufacturer Name
H&C Products Group
Emergency telephone
(800) 424-9300, (216) 566-2902
Icons in SDS
Company Information
company name
H&C Products Groups
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H350, H373
Hazard statements
Code
Statements
H350
May cause cancer
Section 2
SECTION 2: Hazards identification
Classification of the substance or mixture CARCINOGENICITY - Category 1A SPECIFIC TARGET ORGAN TOXICITY (REPEATED EXPOSURE) - Category 2
Ingredient(s) with unknown acute toxicity
2.1% (dermal), 2.1% (inhalation)
Signal word
Danger
Hazard statements
May cause cancer. May cause damage to organs through prolonged or repeated exposure.
Precautionary statements
General : Read label before use. Keep out of reach of children. If medical advice is needed, have product container or label at hand.
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Wear protective gloves, protective clothing and eye or face protection. Do not breathe vapor.
Response
IF exposed or concerned: Get medical advice or attention.
Storage
Store locked up.
Disposal
Dispose of contents and container in accordance with all local, regional, national and international regulations.
Supplemental label elements
WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Adequate ventilation required when sanding or abrading the dried film. If Adequate ventilation cannot be provided wear an approved particulate respirator (NIOSH approved). Follow respirator manufacturer's directions for respirator use. DELAYED EFFECTS FROM LONG TERM OVEREXPOSURE. Abrading or sanding of the dry film may release Crystalline Silica which has been shown to cause lung damage and cancer under long term exposure. This product contains a component that is either subject to a CEPA ministerial condition or an existing/proposed SNAC (Significant New Activity). See Environmental Data Sheet (EDS) for additional detail. Please refer to the SDS for additional information. Keep out of reach of children. Do not transfer contents to other containers for storage.
2.3 Other hazards
None known.
2.1 Classification of the substance or mixture
CARCINOGENICITY - Category 1A substance or mixture SPECIFIC TARGET ORGAN TOXICITY (REPEATED EXPOSURE) - Category 2 Percentage of the mixture consisting of ingredient(s) of unknown acute toxicity: 2.1% (dermal), 2.1% (inhalation)
