Note: Ingredients listed on restricted chemical lists
EC/CAS
14807-96-6
Name of the chemical
Talc
Concentration
≤10
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
≤10
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
<1
EC/CAS
1333-86-4
Name of the chemical
carbon black
Concentration
≤1
General Information
Revision date
2020-10-13
Product name
SHIELD-CRETE Epoxy Concrete Decorative Flakes
1.2.1 Relevant identified uses
Paint or paint related material
Manufacturer Name
H&C Products Group
Emergency telephone
(800) 424-9300, (216) 566-2902
Icons in SDS
Company Information
company name
H&C Products Group
GHS Information
Signal word
Danger
Section 2
2.1 Classification of the substance or mixture
COMBUSTIBLE DUSTS CARCINOGENICITY - Category 1A SPECIFIC TARGET ORGAN TOXICITY (REPEATED EXPOSURE) - Category 1
Signal word
Danger
Hazard statements
May cause cancer. Causes damage to organs through prolonged or repeated exposure. (lungs) May form combustible dust concentrations in air.
Precautionary statements
General : Read label before use. Keep out of reach of children. If medical advice is needed, have product container or label at hand.
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Wear protective gloves, protective clothing and eye or face protection. Do not breathe dust or mist. Do not eat, drink or smoke when using this product. Wash thoroughly after handling.
Response
IF exposed or concerned: Get medical advice or attention.
Storage
Store locked up.
Disposal
Dispose of contents and container in accordance with all local, regional, national and international regulations.
Supplemental label elements
Keep container tightly closed. Keep away from heat, hot surfaces, sparks, open flames elements and other ignition sources. No smoking. Prevent dust accumulation. WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Adequate ventilation required when sanding or abrading the dried film. If Adequate ventilation cannot be provided wear an approved particulate respirator (NIOSH approved). Follow respirator manufacturer's directions for respirator use. DELAYED EFFECTS FROM LONG TERM OVEREXPOSURE. Abrading or sanding of the dry film may release Crystalline Silica which has been shown to cause lung damage and cancer under long term exposure. Please refer to the SDS for additional information. Keep out of reach of children. Do not transfer contents to other containers for storage.
2.3 Other hazards
None known.