Note: Ingredients listed on restricted chemical lists
EC/CAS
556-67-2
Name of the chemical
D4
Concentration
N/A
EC/CAS
63148-62-9
Name of the chemical
polydimethylsiloxane (Mw > 6 800 Da)
Concentration
N/A
EC/CAS
209-136-7
Name of the chemical
Octamethylcyclotetrasiloxane
Concentration
N/A
General Information
Revision date
2020-06-25
Product name
HVMT Orange
Product Synonyms
Silicone Rubber Coated Fiberglass Tape with Silicone Adhesive
1.2.1 Relevant identified uses
of the product
Emergency telephone
905 564 6712 Available between the hours 08 30 to 17 00 (EST
Icons in SDS
Company Information
company name
Green Belting Industries Limited
e-mail address of the competent person responsible for the Safety Data Sheet
sds-support@greenbelting.com
GHS Information
Signal word
Warning
Section 2
Physical hazards
Flammable liquid Category 3
Health hazards
Reproductive toxicity Category 3
Environmental hazards
Not applicable
Signal word
Warning
Hazard statements
Flammable liquid and vapour Suspected of damaging fertility or the unborn child
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Keep away from heat/sparks/open flames/hot surfaces. — No smoking. Keep container tightly closed. Ground/bond container and receiving equipment. Use explosion-proof electrical/ventilating/lighting/equipment. Use only non-sparking tools. Take precautionary measures against static discharge. Wear protective gloves/protective clothing/eye protection/face protection. Use personal protective equipment as required.
Response
IF exposed or concerned: Get medical advice/attention. IF ON SKIN (or hair): Remove/Take off immediately all contaminated clothing. Rinse skin with water/shower. In case of fire: Use Carbon dioxide (CO2), Foam, Dry Chemical for extinction.
Storage
Store in a well-ventilated place. Keep cool. Store locked up.
Disposal
Dispose of contents/container in accordance with local/regional/national /international regulations.
2.3 Other hazards
Use of this product is not normally considered hazardous, however material dust caused by cutting, sawing or sanding may cause eye or skin irritation. Processing at temperatures higher than 300oC will result in thermal decomposition and may release carbon monoxide, and silicon dioxide may also be released. In all cases avoid exposure, move the individual to fresh air and consult a physician if severe.
