Note: Ingredients listed on restricted chemical lists
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
N/A
EC/CAS
1305-62-0
Name of the chemical
Calcium dihydroxide
Concentration
N/A
General Information
Product name
Gold Bond‰ Veneer Plaster Products
1.2.1 Relevant identified uses
White finish plasters with specific uses in one or two coat veneer systems. For application over basecoat plasters, Kal-Kore baseboard or cementitious base. Use per manufacturer’s recommendations
1.2.2. Uses advised against
Use in well-ventilated area and avoid breathing dust. Avoid skin contact
Emergency telephone
Director Quality Services – National Gypsum Services Company
Icons in SDS
Company Information
company name
Gold Bond Building Products, LLC
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H314, H318, H332, H350, H372
Hazard statements
Code
Statements
H314
Causes severe skin burns and eye damage
Section 2
SECTION 2: Hazards identification
GHS Classification UNITED STATES (US) According to OSHA 29CFR 1910.1200 (HCS)
Classification according to GHS
Carcinogenicity - Category 1A - (H-350) Specific target organ toxicity, repeated exposure – Category 1 (H-372) Acute toxicity, inhalation - Category 4 (H-332) Skin corrosion/irritation Category 2 (H314) Serious eye damage/eye irritation – Category 1 (H-318)
Health hazards
Corrosion
Hazard statements
H-350 May cause cancer H-332, 372 Harmful if inhaled. Causes damage to organs (lungs) through prolonged or repeated exposure. H-314, 318 Causes severe skin burns and eye damage 1
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Do not breathe dust. Use personal protective equipment as required. (See Section 8) Use engineering controls and wet methods to minimize dust.
Response
If breathing is difficult, remove victim to fresh air and keep at rest in a position comfortable for breathing. If on skin, wash with plenty of soap and water. If in eyes, rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Get medical attention if exposed or concerned.
Storage
Store material in a cool, dry, ventilated area, away from excessive heat or sunlight.
Disposal
Dispose of material in accordance with federal, state, and local regulations. Do not wash material down drains.
