Note: Ingredients listed on restricted chemical lists
EC/CAS
7732-18-5
Name of the chemical
Water, distilled, conductivity or of similar purity H2O
Concentration
N/A
General Information
Revision date
2014-07-06
Product name
Your Last Coat
CAS No.
7732-18-5
1.2.1 Relevant identified uses
Encasement TopCoat
Manufacturer Name
GLOBAL Encasement, Inc
Icons in SDS
Company Information
company name
GLOBAL Encasement, Inc
Section 2
SECTION 2: Hazards identification
OSHA EFFECTS OF OVER EXPOSURE: Flammability Inhalation: Vapors or spray mists may be slightly irritating to the eyes, nose, throat, and mucous membrane of the respiratory tract, producing symptoms of a headache and nausea in poorly ventilated Reactivity Health areas. Eye Exposure: Direct contact; slightly irritating to eyes.! Special Skin exposure: Prolonged or repeated contact with coating may cause slight skin irritation. HAZARD INDEX: 0=Minimal, 1=Slight Ingestion: 2=Moderate, 3=Serious, 4=Severe May cause nausea. SECTION IV – FIRST AID INFORMATION EMERGENCY FIRST AID PROCEDURES: For inhalation, move subject to fresh air. For eye contact, flush with a large amount of water for at least 15 minutes. See a physician if irritation persists. Wash affected skin area with soap and water. If swallowed dilute by giving 2 glasses of water to drink. Call a physician. Never give anything by mouth to an unconscious subject. MATERIAL SAFETY DATA SHEET Your Last Coat™ SECTION V – FIRE AND EXPLOSION INFORMATION FLAMMABILITY CLASSIFICATION: DOT - Not Regulated Flash Point – Non Combustible LEL - N/A EXTINGUISHING MEDIA: N/A UNUSUAL FIRE & EXPLOSION HAZARDS: Material can splatter above 212°F Polymer film can burn. SPECIAL FIRE FIGHTING PROCEDURES: For fires involving this material, do not enter any enclosed or confined fire space without proper protective equipment, including self-contained breathing apparatus to protect against the hazardous effects of normal products of combustion or oxygen deficiency. SECTION VI – ACCIDENTAL RELEASE MEASURES STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Keep unnecessary people away. Dike and contain with inert absorbent material (sand, earth, etc.). Transfer to containers for recovery or disposal. Floors may be slippery; use care to avoid falls. Flush final traces with water. SECTION VII – HANDLING AND STORAGE INFORMATION PRECAUTIONS TO BE TAKEN IN HANDLING: Do not take internally. Use approved clothing when using Your Last Coat™. Also, follow all applicable OSHA & EPA, (etc.) regulations concerning normal latex paint spraying activities. PRECAUTIONS TO BE TAKEN IN STORING: Maximum storage temperature 100°F. Keep container tightly closed and upright to prevent leakage. Precautionary labeling: “Keep from Freezing,” product may coagulate. Material may develop bacterial odor on long-term storage if contaminated. KEEP AWAY FROM CHILDREN. SECTION VIII – EXPOSURE CONTROLS / PERSONAL PROTECTION INFORMATION RESPIRATORY PROTECTION: None required if good ventilation is maintained. Wear MSHA/NIOSH approved dust respirator during spray applications. ! VENTILATION: Sufficient ventilation, in pattern and volume, should be provided to keep the air contaminant concentration below applicable exposure limits. All application areas should be ventilated in accordance with OSHA regulation 29 CFR Part 1910.94. PROTECTIVE GLOVES: Impervious gloves for prolonged or repeated contact. ! EYE PROTECTION: Use safety eyewear including side shields, face shields, or chemical splash goggles (ANSI 2-87.1) or approved equivalent. SECTION IX – PHYSICAL AND CHEMICAL PROPERTIES Physical Form: Liquid Odor: Mild scent Color: White Lbs/Gal: 11.85 Flash Point: N/A pH: 9-10.5 Specific Gravity (water = 1.0): 1.42 Viscosity (KU): 100-120 VOC: Zero MATERIAL SAFETY DATA SHEET Your Last Coat™ SECTION X – STABILITY AND REACTIVITY INFORMATION STABILITY: Stable.! HAZARDOUS POLYMERIZATION: Will not occur.! HAZARDOUS DECOMPOSITION PRODUCTS: Will not occur.! CONDITIONS TO AVOID: Keep from freezing.! INCOMPATIBILITY: None reasonably foreseeable. SECTION XI – TOXICOLOGICAL INFORMATION (will only print available data) Carcinogenicity? NO Refer to section VII for proper handling. No other toxicological information available. SECTION XII – ECOLOGICAL INFORMATION AQUATIC TOXICITY: Non-toxic TERRESTRIAL TOXICITY: Non-toxic No other ecological information available. SECTION XIII – DISPOSAL INFORMATION WASTE DISPOSAL METHOD: Disposal should be in accordance with Federal, State and local regulations for water base coatings. Refer to section XV for more information. SECTION XIV – TRANSPORTATION INFORMATION DOT CLASSIFICATION: Non-hazardous.
UN Number
None SECTION XV – REGULATORY INFORMATION SARA TITLE III, SECTION 313, SUPPLIER NOTIFICATION. This product contains none of the toxic chemicals subject to the reporting requirements of the Emergency Planning and Community Right-To- Know Act of 1986 and of CFR 372. SECTION XVI – OTHER INFORMATION The information contained herein is to the best of our knowledge and belief has been compiled from sources considered to be dependable and is accurate and reliable to the best of our knowledge and belief but is not guaranteed to be so. Since conditions of use are beyond our control, we make no warranties, expressed or implied, except those that may be contained on our written contract of sale or acknowledgment. Information complies with New Jersey DOH Right-To-Know Labeling Law (N.J.A.C. 8:59 –5.1 & 5.2) PrepLESS Primer™ SECTION I – PRODUCT AND COMPANY IDENTIFICATION PRODUCT NAME: PrepLESS Primer™ PRODUCT USE: Primer-Sealer-Neutralizer
Product definition
100% Acrylic Copolymer, Water-Base Manufacturer: GLOBAL Encasement, Inc. 701 E. Santa Clara St., Ventura, CA 93001 Contact #s: Tel. # (800) 266-3982 / Fax (800) 520-3291 Website Address: www.encasement.com! SECTION II – COMPONENT INFORMATION Material or Component: CAS No.: Styrene/acrylate copolymer: Not Hazardous Water: 7732-18-5 OSHA PEL or ACGIH TLV: This product contains no hazardous ingredients as per OSHA 29 CFR 1910.1200 SECTION III – HAZARDS IDENTIFICATION EFFECTS OF OVER EXPOSURE: Flammability Inhalation: Vapors or spray mists may be slightly irritating to the eyes, nose, throat, and mucous membrane of the respiratory tract, producing symptoms of a headache and nausea in poorly ventilated Health Reactivity areas. Eye Exposure: Direct contact; slightly irritating to eyes.! Special Skin exposure: Prolonged or repeated contact with coating may cause slight skin irritation. HAZARD INDEX: 0=Minimal, 1=Slight Ingestion: 2=Moderate, 3=Serious, 4=Severe May cause nausea. SECTION IV – FIRST AID INFORMATION