GCR 6 Topcoat

Health hazards

(ACUTE AND CHRONIC) SPECIFIC GRAVITY (H2O=1): 1.05 Acute - Depending on degree of exposure material may cause VAPOR DENSITY: Lighter than air eye, nose, respiratory tract, and skin irritation. Headache and EVAPORATION RATE: Slower than ether nausea are also symptoms of overexposure. COATING VOC .45 lb/gl MATERIAL VOC .17 lb/gl Chronic - Solvents can be toxic by skin absorption SOLUBILITY IN WATER: Soluble overexposure in some laboratory animals has caused damage

Appearance/Odor

Viscous liquid with slight to kidney, liver and red blood cells. ammonia odor. CARCINOGENICITY: NTP Carcinogen: No / IARC Monographs No

Medical Conditions Generally Aggravated by Exposure

Respiratory conditions, pre-existing skin FLASH POINT: N/A FLAMMABLE LIMITS (in air by volume): disorders, liver or kidney disease. Lower: 1.3 / Upper: 9.5 EMERGENCY AND FIRST AID PROCEDURES: EXTINGUISHING MEDIA: Foam, CO2, dry chemical, water Eye contact - Flush with large amounts of water. If irritation fog, other. persists get immediate medical attention. SPECIAL FIREFIGHTING PROCEDURES: Wear self- Skin Contact - Wash exposed area. Remove contaminated contained breathing apparatus with full face piece. Water can clothing. If irritation persists get prompt medical attention. be used to cool containers. Ingestion - Do not induce vomiting; if vomiting occurs UNUSUAL FIRE AND EXPLOSION HAZARDS: This product spontaneously, keep head lower than hips to avoid aspiration will not support combustion unless all of the water has of fluid into lungs. Get immediate medical attention. evaporated. Inhalation - Remove to fresh air, restore breathing if necessary. Treat symptoms. Get immediate medical attention. V. REACTIVITY DATA VII. PRECAUTIONS FOR SAFE HANDLING AND USE STABILITY: Stable CONDITIONS TO AVOID: Avoid freezing, store in lined or STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED plastic containers, do not mix with solvent based material. OR SPILLED: Eliminate all sources of ignition, dike spill area, INCOMPATIBILITY (MATERIALS TO AVOID): Avoid contact pump out liquid or add absorbent and dispose of material with strong oxidizing agents. properly (see below). Ventilate area well. Inform authorities if HAZARDOUS DECOMPOSITION OR BYPRODUCTS: material enters sewers, watercourses, or land areas. Normal combustion products including carbon dioxide, carbon WASTE DISPOSAL METHOD: Dispose of material in a monoxide and oxides of nitrogen. manner approved by local, state, and federal regulations. HAZARDOUS POLYMERIZATION: Will not occur Before attempting clean-up, refer to hazard caution information in other sections of this sheet. PRECAUTIONS TO BE TAKEN IN HANDLING AND IX. TRANSPORTATION INFORMATION STORING: Use proper storage techniques. Store away from high temperature, sparks, and open flame. Keep closure tight Not classified as hazardous for transport. and upright to prevent leakage or contamination. Containers, U.N. Number: - - even those that have been emptied, can contain explosive Proper Shipping Name: Paint/paint related material vapors. Do not cut, drill, weld, grind on or near containers. Shipping Hazard: - - Static electricity may accumulate and create a fire hazard. Ground equipment and transfer containers. Store in properly Packing Group: - - sealed containers between 40-100° Fahrenheit. Shipping Class: 55 OTHER PRECAUTIONS: Warning - Detectable amounts of ADR/RID: Not regulated chemicals known to the State of California to cause cancer, IMDG: Not regulated birth defects, or other reproductive harm may be found in this Marine Pollutant: No product. Proposition 65 California Health & Safety Code ICAO-TI and IATA-DGR: Not regulated Section 25249.9. This material is for industrial use only. IMO Class: - - Material should only be used after all safety precautions are read and understood by everyone handling material. Do not weld or flame-cut an empty container keep away from X. HMIS RATING children. 0 = Insignificant Fire: 0 VIII. PREVENTIVE MEASURES 1 = Slight Health: 1 2 = Moderate