Note: Ingredients listed on restricted chemical lists
EC/CAS
123-86-4
Name of the chemical
acetic acid, butyl ester
Concentration
5-<10%
EC/CAS
111-15-9
Name of the chemical
2-ethoxyethyl acetate
Concentration
5-<10%
General Information
Version
1.0
Revision date
2022-10-19
Product name
Silcor Top Coat 80 (Hardener)
1.2.1 Relevant identified uses
Waterproofing
1.2.2. Uses advised against
advised against No further relevant information available
Icons in SDS
Company Information
company name
GCP Australia Pty. Ltd
e-mail address of the competent person responsible for the Safety Data Sheet
APMSDS@gcpat.com
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H225, H312, H315, H317, H332, H335, H360
Hazard statements
Code
Statements
H225
Highly Flammable liquid and vapour
Section 2
SECTION 2: Hazards identification
2.1 Classification of the substance or mixture
Flam. Liq. 2 H225 Highly flammable liquid and vapour. Acute Tox. 4 H312 Harmful in contact with skin. Acute Tox. 4 H332 Harmful if inhaled. Skin Irrit. 2 H315 Causes skin irritation. Skin Sens. 1 H317 May cause an allergic skin reaction. Repr. 1B H360 May damage fertility or the unborn child. STOT SE 3 H335 May cause respiratory irritation.
2.2 Label elements
The product is classified and labelled according to the Globally Harmonized System (GHS)
Hazard pictograms
GHS02 GHS07 GHS08
Signal word
Danger
Hazardous Ingredients
Hexane, 1,6-diisocyanato-, homopolymer Xylene (mixture of isomers) 2-ethoxyethyl acetate
Hazard statements
Highly flammable liquid and vapour. Harmful in contact with skin. Harmful if inhaled. Causes skin irritation. May cause an allergic skin reaction. May damage fertility or the unborn child. May cause respiratory irritation. (Contd. of page 1) Flammable
Precautionary statements
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Keep away from heat/sparks/open flames/hot surfaces. No smoking. Ground/bond container and receiving equipment. Use explosion-proof electrical/ventilating/lighting equipment. Use only non-sparking tools. Take precautionary measures against static discharge. Avoid breathing dust/fume/gas/mist/vapours/spray. Wash thoroughly after handling. Use only outdoors or in a well-ventilated area. Contaminated work clothing should not be allowed out of the workplace. Wear protective gloves/protective clothing/eye protection/face protection. IF ON SKIN (or hair): Remove/Take off immediately all contaminated clothing. Rinse skin with water/shower. IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing. IF exposed or concerned: Get medical advice/attention. Call a POISON CENTER/doctor if you feel unwell. If skin irritation or rash occurs: Get medical advice/attention. Take off contaminated clothing and wash it before reuse. In case of fire: Use CO2, powder or water spray to extinguish. Store in a well-ventilated place. Keep container tightly closed. Store in a well-ventilated place. Keep cool. Store locked up. Dispose of contents/container in accordance with local/regional/national/international regulations.
PBT Substances
Not applicable
vPvB Substances
Not applicable