Lithium Foil with Copper Current Collector

SECTION 2: Hazards identification

2.1 Classification of the substance or mixture

Substances and mixtures, which on contact with water, emit flammable gases; Category 1 Corrosive to skin; Category 1A

Hazard pictograms

Flame , Corrosion

Signal word

Danger

Hazard statements

In contact with water releases flammable gases, which may ignite spontaneously Causes severe skin burns and eye damage

Prevention

Keep from any possible contact with water, because of violent reaction and possible flash fire. Protect from moisture. Handle under inert gas, or alternatively may be handled in open atmosphere at room temperature, either coated with mineral oil or where relative humidity is maintained below 50%. To maintain best quality, humidity levels of less than 2% are recommended. Wear safety glasses or goggles for general use. Full flame-resistant face shield required if metal is in a molten state. Wear dry rubber gloves for general use. Wear full flame-resistant clothing if the metal is handled or used in a molten state. Do not breathe dusts or mists. Wash thoroughly after handling.

Response

In case of fire DO NOT USE WATER, SAND OR CARBON DIOXIDE. Use graphite, copper powder, Lith-X (Ansul). If not available, dry sodium chloride, dry (anhydrous) calcium oxide or dry lithium chloride can be used. Wash contaminated clothing before reuse. First Aid See Section 4 of the MSDS.

Storage

See Section 7 of the MSDS.

Disposal

See Section 13 of the MSDS.