This MSDS is applicable to all polyethylene based films manufactured by FlexSol Packaging Corp

Hazardous Ingredients

INFORMATION This product is not hazardous as defined in, 29 CFRI910.1200 SECTION 3 HEALTH INFORMATION & PROTECTION NATURE OF HAZARD EYE CONTACT: Particulates may scratch eye surfaces/cause mechanical irritation. SKIN CONTACT: Negligible hazard at ambient temperatures (-18 to +38 degrees C; 0 to 100 degrees F). Exposure to hot material may cause thermal burns. INHALATION: Negligible hazard at ambient temperature (-18 to 38 Deg C; 0 to 100 Deg F) Vapors and/or aerosols which may be formed at elevated temperatures may be irritating to eyes and respiratory tract. Low order of toxicity. INGESTION: Minimal toxicity. FIRST AID EYE CONTACT: This product is an inert solid. If piece gets in eye, remove as one would any foreign object. SKIN CONTACT: For hot product, immediately immerse in or flush the affected area with large amounts of cold water to dissipate heat. Cover with clean cotton sheeting or gauze and get prompt medical attention. No attempt should be made to remove material from skin or to remove contaminated clothing, as the damaged flesh can be easily torn. INHALATION: First aid is normally not required INGESTION: First aid is normally not required. WORKPLACE EXPOSURE LIMITS OSHA REGULATION 29CFRI910.1000 REQUIRES THE FOLLOWING PERMISSIBLE EXPOSURE LIMITS: 5 mg/m3 (respirable dust), and 15 mg/m3 (total dust) based on the OSHA PEL for nuisance dust. THE ACGIH RECOMMENDS THE FOLLOWING THRESHOLD LIMIT VALUES: a TWA of 10 mg/m3 (total dust) for nuisance dust. M:\MSDSorig\47\4795\47950010.doc The Flexible Solutions company. PRECAUTIONS PERSONAL PROTECTION: For open systems at ambient temperature (-18 to 38 degrees C) where contact is likely, wear safety glasses with side shields. Where contact may occur with hot material. wear thermal resistant gloves, arm protection, and a face shield. VENTILATION: Local exhaust ventilation of process equipment may be needed to control particulate exposures to below the recommended exposure limit. See personal protection recommendations. SECTION 4 FIRE & EXPLOSION HAZARD FLASHPOINT 649 Deg F. METHOD ASTM E136 NOTE Estimated Minimum FLAMMABLE LIMITS NOTE Not applicable AUTOIGNITION TEMPERATURE 649 Deg F. NOTE Estimated Minimum GENERAL HAZARD: Solid material, may burn at or above the flashpoint, and airborne dust may explode if ignited . Toxic gases will form upon combustion. Static Discharge, material can accumulate static charges which can cause an incendiary electrical discharge FIRE FIGHTING: Use water spray to cool fire exposed surfaces, protect personnel, and extinguish the fire. Respiratory and eye protection required for fire fighting personnel. HAZARDOUS COMBUSTION PRODUCTS: Oxygen-lean conditions may produce carbon monoxide and irritating smoke. SECTION 5 SPILL CONTROL/ACCIDENTAL RELEASE PROCEDURE (applicable to material in pellet form only) LAND SPILL: Recover spilled material and place in suitable containers for recycle or disposal. Consult an expert on disposal of recovered material and ensure conformity to local disposal regulations. WATER SPILL: Plastic pellets are defined by the US EPA under the Clean Water Act (40CFRI22.26) as a "significant material" which requires any industrial plant that may expose pellets to storm water to secure a storm water permit. Violations of the rule carry the same penalties as other Clean Water Act violations. Pellets found in storm water runoff are subject to EPA regulations with the potential for substantial fines and penalties. Skim from surface. Consult an expert on disposal of recovered material and ensure conformity to local disposal regulations. Recover the spilled material and place in suitable containers for recycle or disposal. SECTION 6 NOTES NOTES: