36 Stair Tread Epoxy Caulk Part “A”

Appearance/Odor

Grayish mastic, mild epoxy resin odor Evaporation Rate (butyl acetate =1): Not determined V.O.C. <10 g/L % Solids: > 96% IV. Fire and Explosion Hazards Flash Point (Method Used): > 400° F Flammable Limits: Not determined Flammability Classification: OSHA: None DOT: Not regulated Extinguishing Media: Carbon dioxide, Dry chemical or foam. Special Fire Fighting Procedures: None Unusual Fire and Explosion Hazards: None V. Reactivity Data Stability: Stable Conditions to Avoid: In reaction with many curing agents, considerable heat is released. Incompatibility (Materials to Avoid): None Known Hazardous Decomposition Products: Carbon Monoxide, Carbon Dioxide, Aldehydes and acids from incomplete combustion. Hazardous Polymerization: Will not occur. VI. Health Hazard Data Effects of Exposure: Chronic Prolonged or repeated skin exposure can cause skin irritation. Acute Prolonged or repeated exposure can cause mild skin irritation. Irritating to the eyes. Emergency and First Aid Skin: Wash with soap and water or waterless skin cleanser. Followed by soap and water. Get Procedures: medical help if irritation persists. Eyes: Flush with large amounts of water for 15 minutes Get medical help if irritation persists. Ingestion: Get medical attention. VII. Precautions for Safe Handling and Use Steps to be taken in case material is Scrape into containers for disposal. Comply with all federal, state and local regulations. spilled or released: Waste disposal method: Dispose of according to all federal, state and local regulations. Can be incinerated in approved facility if not in closed containers. Handling and Storage Precautions: Keep container tightly closed. Store in a cool dry place. Wash with soap and water before eating, drinking, smoking or using toilet facilities. Launder contaminated clothing before reuse. Transportation Data: See Section I Other Precautions: KEEP OUT OF REACH OF CHILDREN! VIII. Control Measures Respiratory Protection: Not usually required. Use respiratory protection if vapor levels are at or above TLV levels. (Use NIOSH approved respirator.). Ventilation: Use only in well ventilated areas. Protective Gloves: Chemical resistant gloves recommended. Eye Protection: Safety goggles. Hygienic Practices: Good general cleanliness and hygiene. Wash skin and hands after use. Disclaimer: This Safety Data Sheet was prepared to protect against any reasonable exposure to consumers or employees arising out of the intended use of the product and to provide them with information regarding potential hazards contained in the product. Under varied circumstances the hazardous ingredients may pose a lesser or greater hazard. Because of the scientific data contained in these sheets was obtained from tests performed by agencies other than Milamar Adhesives, the company cannot guarantee its accuracy. Milamar Adhesives makes no warranty of any kind, expressed or implied. The user must assume all risk and liability resulting from reliance on the information contained on this Material Safety Data Sheet and the use of this product, whether used in combination with other products or singly. I. Chemical Product and Company Identification Material Identity HMIS H 1 / F 0 / R 1 / P B Product Code and Name: #36 Stair Tread Epoxy Caulk Part “B” Product Class: Adhesive DOT Class: Not Regulated—Limited Quantity Supplier: Flexco, Inc 1401 East 6th Street Tuscumbia, AL 35674 Date Prepared October 5, 1999 Date / Revised: November 1, 2011 24 Hour Emergency: Chem-Tel 1(800) 255-3924