LUBRIPLATE FML-2, FML-1, FML-0

SECTION 2: Hazards identification

Ingredients with CAS#’s CAS# Percentage Mineral Oil 8042-47-5 70 - 75% Polybutene 9003-29-6 10 - 15% Zinc Oxide 1314-13-2 5 - 10% Calcium Thickener 3159-62-4 5 - 10% Hazardous Material Identification System (HMIS): Health - 1, Flammability - 1, Reactivity – 0 Not a Controlled Product under (WHMIS) - Canada Special Protection: See Section 9 Section 3 - Health Hazard Data Threshold Limit Value 5 mg/m3 for oil mist in air. OSHA Regulation 29 CFR 1910.1000 Effects of Overexposure Prolonged or repeated skin contact may cause skin irritation. Product contacting the eyes may cause eye irritation. Human health risks vary from person to person. As a precaution, exposure to liquids, vapors, mists and fumes should be minimized. This product has a low order of acute oral toxicity, but minute amounts aspirated into the lungs during ingestion may cause mild to severe pulmonary injury. Carcinogenicity: NTP? No IARC Monographs? No OSHA Regulated? No Section 4 - Emergency and First Aid Procedures EYE CONTACT: Flush with clear water for 15 minutes or until irritation subsides. If irritation persists, consult a physician. SKIN CONTACT: Remove any contaminated clothing and wash with soap and warm water. If injected by high pressure under skin, regardless of the appearance or its size, contact a physician IMMEDIATELY. Delay may cause loss of affected part of the body. INHALATION: Vapor pressure is very low and inhalation at room temperature is not a problem. If overcome by vapor from hot product, immediately remove from exposure and call a physician. INGESTION: If ingested, call a physician immediately. Do not induce vomiting. Section 5 - Fire and Explosion Hazard Data Flash Point (Method Used) COC - 435oF Flammable Limits LEL 0.9% UEL 7.0% Extinguishing Media Foam, Dry Chemical, Carbon Dioxide or Water Spray (Fog) Special Fire Fighting Procedures Cool exposed containers with water. Use air-supplied breathing equipment for enclosed or confined spaces. Unusual Fire and Explosion Hazards Do not store or mix with strong oxidants. Empty containers retain residue. Do not cut, drill, grind, or weld, as they may explode. PRODUCT NAME OR NUMBER - LUBRIPLATE FML-2, FML-1, FML-0 Section 6 - Physical/Chemical Characteristics