Note: Ingredients listed on restricted chemical lists
EC/CAS
64742-89-8
Name of the chemical
Solvent naphtha (petroleum), light aliph
Concentration
≥25-≤50
EC/CAS
14807-96-6
Name of the chemical
Talc
Concentration
≤10
EC/CAS
106-97-8
Name of the chemical
n-Butan, enthält 0,1% Butadien
Concentration
≤10
EC/CAS
123-86-4
Name of the chemical
acetic acid, butyl ester
Concentration
≤10
General Information
Revision date
2018-04-02
Product name
KRYLON Industrial QUIK-MARK Solvent-Based Inverted Marking Paint (Fluorescent) Orange
Emergency telephone
(216) 566-2917, (216) 566-2902, (800) 424-9300, 1-800-222-1222
Icons in SDS
Company Information
company name
F4P
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H222, H229, H280, H304, H315, H335, H336, H351, H372
Hazard statements
Code
Statements
H222
Extremely flammable aerosol
Section 2
Ingredient(s) with unknown acute toxicity
47%Percentage of the mixture consisting of ingredient(s) of unknown dermal toxicity: 47%Percentage of the mixture consisting of ingredient(s) of unknown inhalation toxicity: 45. 6%
Signal word
Danger
Hazard statements
Extremely flammable aerosol. Contains gas under pressure; may explode if heated. Causes skin irritation. Suspected of causing cancer. May be fatal if swallowed and enters airways. May cause respiratory irritation. May cause drowsiness or dizziness. Causes damage to organs through prolonged or repeated exposure. (lungs)
Prevention
Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Do not spray on an open flame or other ignition source. Use only outdoors or in a well-ventilated area. Do not breathe dust or mist. Do not eat, drink or smoke when using this product. Wash hands thoroughly after handling. Pressurized container: Do not pierce or burn, even after use.
Response
Get medical attention if you feel unwell. IF INHALED: Remove person to fresh air and keep comfortable for breathing. Call a POISON CENTER or physician if you feel unwell. IF SWALLOWED: Immediately call a POISON CENTER or physician. Do NOT induce vomiting.
Storage
Store locked up. Protect from sunlight. Do not expose to temperatures exceeding 50 °C/122 °F. Store in a well-ventilated place.
Disposal
Dispose of contents and container in accordance with all local, regional, national and international regulations.
Supplemental label elements
DELAYED EFFECTS FROM LONG TERM OVEREXPOSURE. Contains solvents which can cause permanent elements brain and nervous system damage. Intentional misuse by deliberately concentrating and inhaling the contents can be harmful or fatal. WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. FOR INDUSTRIAL USE ONLY. Please refer to the SDS for additional information. Keep out of reach of children. Keep upright in a cool, dry place. Do not discard empty can in trash compactor.
2.3 Other hazards
DANGER Rags, steel wool, other waste soaked with this product, and sanding residue may spontaneously catch fire if improperly discarded. Immediately place rags, steel wool, other waste soaked with this product, and sanding residue in a sealed, water-filled, metal container. Dispose of in accordance with local fire regulations
2.1 Classification of the substance or mixture
This material is considered hazardous by the OSHA Hazard Communication Standard substance or mixture: (29 CFR 1910.1200). FLAMMABLE AEROSOLS - Category 1 GASES UNDER PRESSURE - Compressed gas SPECIFIC TARGET ORGAN TOXICITY (SINGLE EXPOSURE) (Respiratory tract irritation) - Category 3 SPECIFIC TARGET ORGAN TOXICITY (SINGLE EXPOSURE) (Narcotic effects) - Category 3 SPECIFIC TARGET ORGAN TOXICITY (REPEATED EXPOSURE) (lungs) - Category 1 ASPIRATION HAZARD - Category 1 Percentage of the mixture consisting of ingredient(s) of unknown oral toxicity: 47%Percentage of the mixture consisting of ingredient(s) of unknown dermal toxicity: 47%Percentage of the mixture consisting of ingredient(s) of unknown inhalation toxicity: 45. 6%