EWI-265 ONE COAT RENDER (OCR)

Hazard statements (CLP)

H315, H317, H318, H335

Code

Statements

H315

Causes skin irritation

2.2 Label elements

Labelling according to Regulation (EC) No 1272/2008 2 GHS05 corrosion GHS07 WARNING Eye Dam. 1 H318 Causes serious eye damage. Skin Irrit. 2 H315 Causes skin irritation. Skin Sens. 1 H317 May cause an allergic skin reaction. STOT SE 3 H335 May cause respiratory irritation.

Additional information

The classification in terms of skin and eye irritation is based on the results of animal studies, see section 16 literature [4], [11] and [12]. The product is classified and labelled according to the CLP regulation.

Hazard pictograms

GHS05 GHS07

Signal word

Danger

Hazardous Ingredients

Calcium dihydroxide Portland cement clinker

Precautionary statements

H315 Causes skin irritation. H318 Causes serious eye damage. P102 - Keep out of reach of children. H317 May cause an allergic skin reaction. P261 - Avoid breathing dust. H335 May cause respiratory irritation. P271 Use only outdoors or in a well-ventilated area. P280 Wear protective gloves/protective clothing/eye protection/face protection. P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if possible. Continue rinsing. P315 Seek immediate medical advice/attention. P302+P352 IF ON SKIN: Wash with plenty of soap and water. P332+P313 If skin irritation occurs: Seek medical advice/attention. P362+P364 Take off contaminated clothing and wash it before re-use. P304+P340 IF INHALED: Move into well-ventilated area for ease of breathing. P501 Dispose of contents/container to appropriate waste collection point.

2.3 Other hazards

As soon as the dry mixture comes into contact with water or humidity, a strongly alkaline solution will be formed. Wet mortar may cause skin and eye irritation due to its high alkalinity. Prolonged contact (e.g. knees in wet mortar) increases the risk of serious skin damage due to the alkalinity. The amount of respirable, cristaline siliciumdioxide is below 1%. The product is not subject to a declaration obligation, however, the use of breathing protection is advisable. Dust from the dry mixture can cause respiratory irritation. Frequent inhalation of large amounts of dust increases the risk of developing lung diseases. The mixture is chromate reduced and therefore, there is no risk of sensitisation by chromate. The ready-to-use product (after the addition of water) contains a maximum 0,0002% of soluble chromium(VI) based on the dry weight of the cement. Proper dry storage and compliance with the maximum storage time is required for an effective chromate reduction.

PBT Substances

Not applicable. vPvB Not applicable One Coat Render EWI-265 3