EUTECTOR 190

Hazard statements (CLP)

H302, H314, H335, H410

Code

Statements

H302

Harmful if swallowed

SECTION 2: Hazards identification

EMERGENCY OVERVIEW: Target organ statement DANGER Causes severe burns to skin, eyes, and respiratory system. May be fatal if swallowed or inhaled. Does not pose a fire hazard as shipped. Non-Flammable: However, heat and flames used during brazing and soldering can ignite combustibles. Refer to American National Standard Z49.1 for fire prevention during welding and brazing.

Principle Routes of Exposure

Primary route of entry is the respiratory system. Other possible routes are eyes, ingestion, and/or skin contact.

Hazard statements

Corrosive, Harmful, Dangerous for the environment Contact with acids liberates very toxic gas. Harmful if swallowed. Causes burns. Toxic to aquatic organisms, may cause long-term adverse effects in the aquatic environment. Although this product does not require a hazard warning label in all countries, we recommend the following GHS pictograms: GHS07- GHS05 – GHS09 Danger Corrosive Environment Contains zinc chloride. H302 Harmful if swallowed. H314 Causes severe skin burns and eye damage. H335 May cause respiratory irritation. H410 Very toxic to aquatic life with long lasting effects.

Precautionary statements

P285 In case of inadequate ventilation wear respiratory protection. P314 Get medical advice/attention if you feel unwell. P280 Wear protective gloves/protective clothing/eye protection/face protection. P202 Do not handle until all safety precautions have been read and understood. P260 Do not breathe dust/fume/gas/mist/vapours/spray. P501 Dispose of contents/container to waste treatment facility in accordance with local and national regulations. WARNING This product contains or produces a chemical known to the State of California to cause birth defects (or other reproductive harm) and cancer. (California Health & Safety Code 25249.5 et seq.). WARNING: avoid breathing welding fumes and gases; they may dangerous to your health. Always use adequate ventilation and use appropriate personal protection equipment. CARCINOGENICITY WELDING FUMES (not otherwise specified) are considered to be carcinogenic defined with no further categorization by NIOSH and IARC. See additional information in Section 3 for ingredients. Before using this product, contact your doctor to determine if exposure to product or use of this product will aggravate your medical conditions. Spatter and flames from brazing and soldering may cause burns and start fires.