AND INFORMATION

SECTION 2: Hazards identification

Toxicological hazard Little hazard to respiratory tract if inhaled. Cause mild skin irritation. In case of contact with eyes, causes temporarily irritation. Little harmful to health if swallowed.

Other physicochemical hazards

Particular Hazard Combustible Flammability No information available FIRST AID MEASURES Inhalation Skin Contact Eye contact If Inhaled, move victim to fresh air and seek medical attention. Wash off with soap and plenty of water. Get medical attention if symptoms occur. In case of eye contact, immediately flush eyes with plenty of water for at least 15 minutes and get medical attention if irritation persists. Ingestion Induce vomiting immediately and call a physician. ACCIDENT RELAEASE MEASURES Suitable extinguishing media: Special fire fighting procedures Foam, powder, carbon dioxide Remove sources of combustibles. Extinguish the fire using fire-fighting media listed above. The fire fighting should be done from the windward side, with suitable respiratory protective device, if necessary. Cool containers / tank with water spray. ACCIDENT RELAEASE MEASURES Personal precautions Use personal protective equipment. Keep people away from the area. Work from the windward side. Remove all sources of ignition. Environmental precautions: Methods for cleaning up Do not flush into surface water or sanitary sewer system. Put in an empty container for recovery after preventing spill by sand or sandbags, if the amount of spill is large. Put in an empty container for recovery after wiping or soaking up in an inert material, if the amount of spill is small. HANDLING AND STORAGE Handling- technical measure Advice on safe handling

Storage

Storage requirement Safety packaging material Wear eye and hand protection when in handling. Avoid any source of ignition due to flammability. Store in a dark, cool place indoors, with container tightly closed No information available. EXPOSURE CONTROLS / PERSONAL PROTECTION Facility / Engineering measures Standard Control Limit (SCL) / Permissible Exposure Limit (PEL) Personal Protective equipment Respiratory Protection Hand Protection Eye Protection Skin and body protection Well ventilated area Eyewash stations Not established. Not applied Rubber or plastics gloves Safety glasses with side-shields Rubber boots and protection. PHYSICAL/ CHEMICAL CHARACTERISTICS Physical state Colour Odor Boiling Point Melting Point Flash point Ignition temperature Explosion limit liquid Clear No odor No data available 330 deg C 450 deg C Vapour pressure Density pH Soluble in Water Soluble in other solvents No data available 0.97g/cm3/25 deg C Not applied Insoluble STABILITY AND REACTIVITY DATA Stability: Reactivity The substances are moderately stable. The catalysis of strong acids or bases causes polymerization or decomposition. Hazardous decomposition products: May generate formaldehyde at temperatures greater than 150 C FIRE AND EXPLOSION DATA Flash Point and method used: NA Auto ignition Temperature: NA Flammable Limits in air % by volume: NA Fire Extinguishing Media: All standard firefighting media Sensitivity to Mechanical impact (Y/N) No Sensitivity to static discharge : Not expected Special Fire-fighting procedures: NA