Note: Ingredients listed on restricted chemical lists
EC/CAS
207-312-8/461-58-5
Name of the chemical
dicyanodiamide
Concentration
≥32
General Information
Revision date
2023-12-11
Product name
FSS-FIRE SUPPRESSION SYSTEMS
Product name
FSS-FIRE SUPPRESSION SYSTEMS
Identification on the label/Trade name
ESP International Srl
Manufacturer Name
Plant
Emergency telephone
+39 0141 945628
Icons in SDS
Company Information
company name
ESP International Srl
e-mail address of the competent person responsible for the Safety Data Sheet
e.perna@fss-esp.com
GHS Information
Signal word
General Statements
Hazard Codes
Hazard statements (CLP)
H272
Hazard statements
Code
Statements
H272
May intensify fire; oxidiser
Section 2
SECTION 2: Hazards identification
OSHA Regulatory Status Classification of the substance or mixture
Hazard pictograms
GHS03 1
Signal word
General Statements: P102 Keep out of the reach of children P103 Read label instructions before use
Prevention
P210 Keep away from heat/sparks/open flames/hot surfaces. — Do not smoke. P221 Take any precaution and keep away from combustible material P243 Avoid electrostatic loads P250 Avoid crash and strike P273 Do not waste the product and/or the casing
Response
Fluid Aerosol P302+P350+P313 In case of skin contact: may cause redness or irritation. Rinse cautiously with running water. If skin irritation occurs get medical advice/attention. P304+P340+P313 In case of inhalation: remove to fresh air and keep at rest in a position comfortable for breathing. Get medical attention for any breathing difficulty. P305+P351+P313 In case of eye contact: may cause redness or irritation. Rinse cautiously with running water for several minutes. If eye irritation persists, get medical advice/attention. P314 Seek medical attention for further treatment, observation, and support if necessary. P370+P380 In the event of a fire, evacuate the area and inform emergency services. Ignition of FSS Fire Suppression Systems produces a fire suppression aerosol. P370+P378 Water may be used as an additional suppression agent, as well as powder extinguisher and/or CO2 extinguisher.
Precautionary statements
Disposal P501 Disposal should be in accordance with applicable national, state and local environmental control regulations.
2.3 Other hazards
The substance does not have persistence, bioaccumulation, and toxicity (PBT) properties and is not very persistent and very bio accumulative. The substance does not have endocrine disrupting properties.
2.1 Classification of the substance or mixture
OSHA regulatory status: all 3 chemicals listed below are not stored as raw loose powder but homogenously blended and pressed into a single solid forming compound pellet. Exposure to raw dust from the pellet is very limited which may contain any of the 3 chemicals listed in Section 3. Any additional information concerning the risks for health and/or the environment are given in sections 11 and 12 of this sheet. Not classified as Hazardous according to the Globally Harmonized System of Classification and
