Note: Ingredients listed on restricted chemical lists
EC/CAS
90-72-2
Name of the chemical
2,4,6-tris(dimethylaminomethyl)phenol
Concentration
30-40 20-30 20-30 5-10
General Information
Revision date
2013-03-11
Product name
ENTHONE CATALYST B-3 PART B
CAS No.
90-72-2
1.2.1 Relevant identified uses
Specialty chemicals for the electronics and surface finishing industries
Manufacturer Name
Enthone Inc
Emergency telephone
(203) 799-8179, 52 55 5078 3904, 55 11 4353 2500, 52 555 567 6326, 55 11 4353 2521, (203)-799-4940
Icons in SDS
Company Information
company name
Enthone Inc
GHS Information
Signal word
DANGER!
Hazard Codes
Hazard statements (CLP)
H301+H311
Hazard statements
Code
Statements
H301+H311
Toxic if swallowed or in contact with skin
Section 2
SECTION 2: Hazards identification
OSHA Physical state Liquid. Odor Amine-like.
Principle Routes of Exposure
Dermal contact. Eye contact. Inhalation. Ingestion.
Potential Acute Health Effects
Page: 2/10 2. Inhalation Toxic by inhalation. Can cause target organ damage. Corrosive to the respiratory system. May cause burns to mouth, throat and stomach. May cause sensitization by inhalation. Once sensitized, a severe allergic reaction may occur when subsequently exposed to very low levels. Adverse symptoms may include the following: wheezing and breathing difficulties asthma anaphylactic shock Persons with a history of asthma, allergies or chronic or recurrent respiratory disease should not be employed in any process in which this product is used. Exposure to decomposition products may cause a health hazard. Serious effects may be delayed following exposure. The exposed person may need to be kept under medical surveillance for 48 hours. Exposure can cause lung irritation, chest pain and edema, which may be fatal. Ingestion Toxic if swallowed. Corrosive to the digestive tract. May cause burns to mouth, throat and stomach. Can cause target organ damage. Adverse symptoms may include the following: nausea or vomiting stomach pains Ingestion may cause gastrointestinal irritation and diarrhea. Skin Corrosive to the skin. Causes burns. Prolonged or repeated contact with skin or mucous membrane may result in irritation symptoms, such as redness, blistering, dermatitis etc. Toxic in contact with skin. This product contains material(s) that are absorbed through the skin. Can cause target organ damage. and symptoms similar to those listed under inhalation or ingestion. May cause sensitization by skin contact. Prolonged or repeated contact may cause dermatitis. Once sensitized, a severe allergic reaction may occur when subsequently exposed to very low levels. In the event of any complaints or symptoms, avoid further exposure. Persons with a history of skin sensitization problems should not be employed in any process in which this product is used. Eyes Corrosive to eyes. Causes burns. Direct contact with the eyes can cause irreversible damage, including blindness. Potential chronic health effects
Potential chronic health
Contains material that can cause target organ damage. Adverse symptoms may include the following: Glycol Ether.: Aliphatic amine.: Prolonged or repeated contact may cause dermatitis. Amine Salt: Prolonged skin contact may cause dermatitits. Target organs Contains material which may cause damage to the following organs: blood, kidneys, liver, mucous membranes, heart, bladder, lymphatic system, upper respiratory tract, skin, central nervous system (CNS), eye, lens or cornea. Carcinogenicity
Teratogenic Effects
Contains material which may cause birth defects, based on animal data. Developmental effects Not classified. Fertility effects Not classified. Medical conditions Pre-existing respiratory, skin and digestive disorders and disorders involving any other aggravated by over- target organs mentioned in this MSDS as being at risk may be aggravated by over- exposure exposure to this product. Persons with a history of skin sensitization problems should not be employed in any process in which this product is used. Persons suffering from respiratory problems or allergic responses should not be exposed to or handle powder coatings. Page: 3/10