Anhydrone (Magnesium perchlorate)

Hazard statements (CLP)

H272, H315, H319, H335

Code

Statements

H272

May intensify fire; oxidiser

SECTION 2: Hazards identification

Regulation (EC) No. 1272/2008 Classification of the substance or mixture

Product definition

10034-81-8 (magnesium-perchlorate)

Hazard pictograms

GHS03 GHS07

Signal word

Danger

Hazard statements

H272 May intensify fire; oxidiser. H315 Causes skin irritation. H319 Causes serious eye irritation. H335 May cause respiratory irritation. EUH014 Reacts violently with water.

Precautionary statements

P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. P261 Avoid breathing dust/fume/gas/mist/vapours/spray. P280 Wear protective gloves/protective clothing/eye protection/face protection. P302+P352 IF ON SKIN: Wash with plenty of soap and water. P304+P340 IF INHALED: Remove person to fresh air and keep comfortable for breathing. P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. P312 Call a POISON CENTER/doctor if you feel unwell. P332+P313 If skin irritation occurs: Get medical advice/attention. P337+P313 If eye irritation persists: Get medical advice/attention. P362 Take off contaminated clothing. P370+P378 In case of fire: Useextinguishing powder, foam or CO2 to extinguish. P405 Store locked up. P501 Dispose of contents/container to hazardous or special waste collection point.

2.3 Other hazards

PBT assessment

2.1 Classification of the substance or mixture

Classification in accordance with Regulation (EC) No 1272/2008 (CLP) EUH014 Eye Irrit. 2; H319 Ox. Sol. 2; H272 Skin Irrit. 2; H315 STOT SE 3; H335 Classification information This product is assessed and classified using the methods and criteria below referred to in Article 9 of Regulation (EC) n° 1272/2008: Physical hazards: determined through assessment data based on the methods or standards referred to in part 2 of Annex I to CLP Health hazards and environmental hazards: determined through toxicological and ecotoxicological assessment data based on the methods or standards referred to in Part 3 and 4 of Annex I to CLP.