ELI-CAST FR 453 HARDENER

Hazardous Ingredients

INGREDIENTS PERCENT Aromatic Di-isocyanate (MDI) SECTION 3 - PHYSICAL DATA Liquid Polyurethane Hardener, For detailed information refer to product Low viscosity, low vapour pressure specification Colour: Brown SECTION 4 - FIRE AND EXPLOSION HAZARD DATA FLASH POINT:± 200°C IGNITION POINT: 250°C EXTINGUISHING MEDIA: Dry Chemical Powder, Carbondioxide, Foam If water is used it should be in large quantities. Care must be taken as the reaction between water and hot isocyanate may be vigorous. UNUSUAL FIRE AND EXPLOSION HAZARDS: N/A SPECIAL FIRE FIGHTING PROCEDURES: Fire fighters must wear full-faced positive pressure self contained breathing apparatus and full protective clothing. SECTION 5 - EMERGENCY & FIRST AID PROCEDURES In all cases of personal exposure to hazardous concentration of TDI and MDI medical attention must be obtained immediately. If overcome by vapours, remove to fresh air. If not breathing, give artificial respiration. Wash skin with soap and water. Flush eyes with large amounts of water for at least 15 minutes. If resin/hardener is ingested, do not induce vomiting, contact a doctor immediately. FR/453 Hardener SECTION 5 - EMERGENCY & FIRST AID PROCEDURES This information is given without a warranty or representation. We do not assume any legal responsibility for same, not do we give permission, inducement, or recommendation to practice any patented invention without a licence. It is offered solely for your consideration, investigation and verification. Before using any product, read its label.

Acute Health Hazards

Eli-Cast FR 453 Hardener - Effects of over-exposure: Prolonged / repeated exposure may cause irritation of the skin, eyes, nose, throat and headaches. SECTION 7 - REACTIVITY DATA MATERIALS TO AVOID Contamination with water, chemicals, oxidating chemicals, oxidating compounds HAZARDOUS DECOMPOSITION PRODUCTS: Carbon oxides, nitrogen oxide, hydrogen cyanide, CONDITIONS TO AVOID: Store in tightly closed containers, keep away from moisture, heat and open flame. SECTION 8 - SPILL OR LEAK PROCEDURES STEPS TO BE TAKEN IN CASE OF SPILLAGE/LEAKAGE: Cover spillage with sand, sawdust, cotton waste, Collect in open top containers. WASTE DISPOSAL PROCEDURES: a) Large quantities by incineration b) Small quantities by reaction with polyol, or flush with 90 % water, 8 % ammonia and 2 % liquid detergent We make no guarantee or warranty of any kind that the use or disposal of this product is in compliance with all federal, state or local laws. It is the obligation of each user of the product mentioned herein to determine and comply with the requirements of all applicable statues. SECTION 9 - SPECIAL PROTECTION INFORMATION RESPIRATORY PROTECTION: N/A VENTILATION: Ensure good ventilation at ambient temperature PROTECTIVE GLOVES: Use gloves EYE PROTECTION: Use goggles OTHER PROTECTIVE EQUIPMENT: N/A SECTION 10 - SPECIAL PRECAUTIONS PRECAUTIONS TO BE TAKEN DURING HANDLING AND STORING: Store under dry and cool conditions